ASSEMBLY
Assembly requires two persons. Set the treadmill in a cleared area and remove all packing materials. Do not dispose of the packing materials until assembly is completed.
Note: The underside of the treadmill walking belt is coated with
Assembly requires the included allen wrenches | and your own phillips screwdriver | , | |
wire cutters | , and needlenose pliers | . |
|
To identify small parts, use the PART IDENTIFICATION CHART attached in the center of this manual.
Note: If a part is not in the parts bag, first check to see if it has been
1.Make sure that the power cord is unplugged.
With the help of a second person, carefully raise the Uprights (38) until the treadmill is in the position shown.
Cut the plastic tie (not shown) off the right Upright (38).
2.Insert one of the Extension Legs (15) into the treadmill as shown. Make sure that the Base Pad (33) is on the indicated side. Note: It may be helpful to tip the Uprights
(38)in the direction shown by the arrow as you insert the Extension Leg.
Attach the Extension Leg (15) with an Extension Leg Screw (14). Make sure to push on the head of the
Extension Leg Screw while tightening it.
Attach the other Extension Leg (15) in the same way.
1
38
2
38
14
15
33
5