3.If there are plastic ties in the brackets on the Handrails (4), remove the plastic ties. Hold one of the Handrails near the right Upright (38) as shown. Insert the Wire Harness (53) up through the bracket on the Handrail and out of the round hole in the side of the Handrail. If neces- sary, use needlenose pliers to pull the Wire Harness out of the hole. Be careful not to damage the Wire
Harness.
Insert the brackets on the Handrails (4) into the upper ends of the Uprights (38).
Finger tighten four 1” Bolts (16) with Handrail Washers
(40)into the Uprights (38) and the Handrails (4).
4.Set the Console Base (87) on the Handrails (4). Thread four 3/4” Screws (5) into the Handrails and the Console Base. After you have started all four Screws, tighten the
Screws until they are snug; do not overtighten the Screws.
Firmly tighten, but do not overtighten, the 1” Bolts (not shown) used in step 3.
Insert the Wire Harness (53) through the two indicated plastic ties on the Console Base (87) and up through the hole in the Console Base.
5.Insert the Battery Cover (12) into the Console Base (87), with the hinges in the position shown. The Battery Cover should pivot down, away from the Console Base.
3 | 4 |
|
|
| |
|
| Connectors |
| 16 | 4 |
| 53 | |
| 40 |
|
|
| Bracket |
| 40 |
|
16 | 38 | 16 |
| ||
|
| 40 |
|
| 16 |
|
| 38 |
4 |
|
|
4 | 53 | 4 |
| ||
|
| |
|
| 87 |
| Plastic Ties | |
| 5 | 5 |
5 |
|
|
|
| 87 |
|
| Hinges |
| 12 |
|
6