3.Hold a Frame Spacer (27) against the right side of the Frame (79) as shown. Insert a 4” Bolt (70) into the indi- cated hole in the Frame Spacer and the Frame. Next, tighten a 3/4” Tek Screw (3) into the Frame Spacer and the Frame. Then, remove the Bolt. Repeat this step on the other side of the Frame.
4.Raise the Right Handrail (59) and the Left Handrail (not shown) so the Base (46) is flat on the floor. Position the Handrails near the Frame (79).
Locate the Wire Harness (60). Next, locate the long piece of tape in the large hole near the lower end of the Right Handrail (59). Wrap the end of the tape around the end of the Wire Harness as shown in drawing 4a. Then, tighten the included plastic tie securely around the tape and the Wire Harness as shown in drawing 4b.
5.Carefully pull the opposite end of the tape to pull the Wire Harness (60) up through the Right Handrail (59) and out of the hole in the side of the Right Handrail.
Attach the end of the ground wire to the Right Handrail
(59)with the Silver Ground Screw (69). Remove the tape from the Wire Harness (60).
3 |
|
| 27 |
| 3 |
| 70 |
79 |
|
4 |
|
| 59 |
| Tape |
| 60 |
4a | 4b |
60 | 60 |
| |
Tape | Tie |
| |
5 |
|
Ground Wire | 69 |
60 |
|
Tape 
59
7