5.2. Operation with image stabilization
-Extract the battery cartridge. To do this, rotate the compartment cover (1) counterclockwise at quarter of the circle. The battery cartridge turns loose and can be extracted easily from the body of the unit. Note: Don’t apply extra strength to the handle!
-Insert six AA batteries into the cartridge observing correct polarity, which is marked on the cartridge bottom.
-Place the cartridge with batteries into the power supply unit and lock it with the cover (1), rotating it clockwise at quarter of the circle. Note: Don’t apply extra strength to the handle!
-In order to power the unit from the car lighter socket, connect the supplied DC converter with the socket (8). The binocular will switch to the external power source automatically (the absence or presence of the battery cartridge does not tell on the unit workability).
-Turn on the device by setting supply voltage switch (5) to ON position and check the power supply unit for proper operation (the indicator (4) must glow brightly).
-In no less than a minute, pull with your thumb the lever (7) in the arrow indicated direction in order to engage the stabilizing mode and hold it in this position while observing.
8
ATTENTION! It is not allowed to engage the stabilizing mode of the device when the power supply control indicator is not glowing, or in less than a minute after device has been turned ON.
After you have finished the observation,
release the lever (7). The lever should return to the initial position. Now the stabilizing mode is switched off. Turn the power switch (5) into the OFF position.
6. STORAGE AND MAINTENANCE INSTRUCTIONS.
Warning! After transportation or keeping the device at temperature lower than
9