. Press the two H_ndlebar Endcaps (13) onto the Pedal Frame (7).
Insert the Handlebar (2) into the Pedal Frame
(7). Be sure that the Handlebar is tumed as shown. Attach the Handlebar to the Pedal Frame with four #8 x 1/2" Screws (16).
3
2 ,
7 J ,3
4.Lubricate the indicated axles on the Pedal Frame (7). Slide a Pedal (12) onto each axle. Be sure that the Pedals are tamed so the rounded ends face away from the Pedal Frame.
Using the included pedal tool, tap a 112" Push Nut (30) onto each of the axles. Sea the inset drawing. Make sure that the Push Nuts are turned as shown, with the teeth pointing away from the Pedal Frame (7).
Attach two Pedals (12) to the other side of the Pedal Frame (7) in the same manner.
5.Turn the Seat Knob (35) to loosen it. Pull down the Seat Knob and hold it, Slide the Seat (3) onto the Seat Frame (5) and move the Seat to the desired position. Release the Seat Knob. Slide the Seat back and forth slightly until the Seat Knob locks into place. Turn the Seat Knob to tighten it. Push on the Seat to make sure that the Seat Knob Is engaged in one of the holes in the underside of the Seat Frame.
P a,TooY |
"I _Teeth
5
5
35
6_