Cannon EASI-TROLL HS, EASI-TROLL /E, LAKE-TROLL owner manual Attaching the Crank Handle Assembly

Page 8

Attaching the crank handle

Attaching the Crank Handle

Assembly

Make sure the thrust bearing is sandwiched between its two races. The thrust bearing spring should be oriented where the narrow end is toward the bearing. Slide the bearing with races and spring over the ratchet shaft. Then, carefully thread the crank handle onto the shaft and continue turning the handle clockwise until the clutch is fully tightened

NOTE: Place your fingertip on the edge of the bearing and races. This allows the crank to be threaded more easily until the spring puts resistance on the clutch pad.

Thrust Bearing

Spring

Races

Crank Handle

 

8

Image 8
Contents EASI-TROLL /E LAKE-TROLL Parts Description BoomMounting Accessories Downrigger Mounting on BoatsSide Rail Mounting Pedestal MountingDecks thicker than 7/16 Installing the Base on Your BoatDecks up to 7/16 thick Low-Profile Swivel Base Mounting the Downrigger on BaseDecks thinner than 1/4 Assemble Swivel Head To Boom Setting Up Your DownriggerAttaching the Boom Attaching the Crank Handle Assembly Terminating the Downrigger Cable Cannon Uni-ReleaseAttaching the Rod Holder Lowering the Weight Raising the WeightAdjusting the Clutch Tension Operating Your DownriggerBlowback Charts BlowbackMaintaining Your Downrigger Trouble ShootingAdjusting the Depth Meter Ten Good Trolling Tips Cannon Limited Warranty Form No Rev C