Stamina Products A450-255 owner manual Walking Resistance, Maintenance

Page 12

OPERATIONAL INSTRUCTIONS

WALKING RESISTANCE

The walking resistance or effort needed to push the treadmill belt can be adjusted by turning the TENSION KNOB(25).

To increase the load, turn the TENSION KNOB(25) clockwise. To decrease the load, turn the TENSION KNOB(25) counterclockwise. There are eight levels for the load adjustment.

NOTE:

1.Since this is a new machine, you may need some time to get used to walking on the treadmill and to break it in.

2.If the walking resistance is too high, check the BELT TENSION. Refer to page 11 for instructions to adjust belt tension.

3.The belt resistance can be reduced by adding silicone lubricant between the belt and the board. Wipe the board under the belt with a clean, dry cloth then spray or spread silicone lubricant on the board under the belt.

MAINTENANCE

The safety and integrity designed into the Avari® Magnetic Treadmill can only be maintained when the Avari® Magnetic Treadmill is regularly examined for damage and wear. Special attention should be given to the following:

1.Adjust the TENSION KNOB(25) and verify that the Magnetic System provides tension. The Magnetic System should provide many years of use.

2.Clean the exposed surfaces of the walking belt and the board with an absorbent cloth.

3.Verify that all nuts and bolts are present and properly tightened. Replace missing nuts and bolts. Tighten loose nuts and bolts.

4.Verify that the CAUTION LABEL(63) is in place and easy to read. Call Stamina Products immediately at 1-800-375-7520 for a replacement CAUTION LABEL(63) if it is missing or damaged.

5.It is the sole responsibility of the user/owner to ensure that regular maintenance is performed.

6.Worn or damaged components shall be replaced immediately or the Avari® Magnetic Treadmill removed from service until repair is made.

7.Only Stamina Products supplied components shall be used to maintain/repair the Avari® Magnetic

Treadmill.

8.Keep your Avari® Magnetic Treadmill clean by wiping it off with an absorbent cloth after use.

9.If the WALKING BELT(10) does not move easily, lubricate the BOARD(9) under the WALKING BELT(10) with silicone lubricant.

12

Image 12
Contents This Product is Distributed Exclusively by Model# A450-255Stamina Products 2040 N. Alliance, Springfield, MOTable of Contents Safety InstructionsCall Us First 800Before YOU Begin Equipment WARNING, Caution & Notice Labels Hardware Identification Chart Part Number and Description100 110 120 130 140 150 Assembly Instructions StepHead SCREWM5x0.8x30mm40 Assembly Instructions SCREWSM5x0.8x10mm41 Operational Instructions Belt Drifting Left Belt Drifting RightRoller w/FLYWHEELS12 Maintenance Walking ResistanceStorage Unfold the Avari Magnetic TreadmillRemove the Locking KNOB33 to unlock the Main FRAME1 BAR8 and screw into the Support BAR8 LATCH57Conditioning Guidelines WARM-UP and COOL-DOWN Product Parts Drawing Parts List PART# Part Name QTYPart Name QTY Limited Warranty WarrantyPage Page To Contact Customer Service To Register Your ProductTo Order Parts