ASSEMBLY
Assembly requires two people. Set the treadmill in a cleared area and remove all packing materials. Do not dispose of the packing materials until assembly is completed. Refer to the drawings below to identify the parts used in assembly. Assembly requires the following tools: The included allen wrench and your own
phillips screwdriver 
and adjustable wrench 
.
Handrail Bolt |
|
| Base Screw/Latch Screw |
|
| Handrail Washer | |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Handrail Screw | Extension Leg Screw |
1.With the help of a second person, carefully lay the treadmill on its right side. Insert one of the Extension Legs (41) into the treadmill as shown. Make sure that the Base Pad (36) is on the bottom of the Extension Leg. Attach the Extension Leg with an Extension Leg Screw
(34).Be sure to push on the head of the Extension Leg Screw while tightening it.
Attach the other Extension Leg (41) as described above.
With the help of a second person, carefully raise the treadmill to the upright position so the Extension Legs
(41)are resting flat on the floor.
2.Refer to HOW TO LOWER THE TREADMILL FOR USE on page 11. Follow the instructions in step 2 to lower the treadmill.
Position one of the Handrails (2) on the left Upright (14) as shown. Thread a Handrail Bolt (15) with a Handrail Washer (16) into the left Upright and the Handrail. Do not tighten the Handrail Bolt yet. Tighten a Handrail Screw
(32)into the lower end of the Handrail. Be sure to push on the head of the Handrail Screw while tightening it. Next, tighten the Handrail Bolt (15).
5
1 | 34 |
41 |
|
36 |
|
41 |
|
36 | 34 |
2 |
|
2 | 15 |
| |
| 16 |
| 14 |
32 |
|