ASSEMBLY
Set the treadmill in a cleared area and remove all packing materials. Do not dispose of the packing materials until assembly is completed. TOOLS REQUIRED FOR ASSEMBLY: An 8" adjustable
wrench _ | (not Included). |
1.Insert the Lock Knob (24), with the Lock Knob Washer (23), into the Upright (7). Raise the Upright, with the Handrail (not shown), to a vertical position and turn the Knob clockwise until almost tight. Leave a little play in the Upright for the following steps.
2.Align the hole in the lower end of the Handrail (1) with the hole in the side of the Frame (41). Insert a Handrail Bolt (80), with a Handrail Washer (20), into the Handrail and tighten the Bolt into the Frame.
3.Tighten the Acorn Nut (6) on the side of the Upright (7).
Tighten the Lock Knob (24) (see step 1).
4.Remove the paper backing from the Wrench Clip (64). Press the Wrench Clip onto the Right Endcap (60) in the indicated location. Press the Allen Wrench (62) into the Wrench Clip.
5. Slide the metal Clothes Clip onto the Pulse Earclip in the
indicated location. The use of the Pulse Earclip is explained in the FITNESS MONITOR section on page 9.
41
62
64
5Pulse Earclip _,_
Make sure that all parts are tightened before using the tread-
6 mill.