ASSEMBLY INSTRUCTIONS
Place all parts from the box in a cleared area and position them on the floor in front of you. Remove all packing materials from your area and place them back into the box. Do not dispose of the packing materials until assembly is completed. Read each step carefully before beginning. If you are missing a part please call our
NOTE: There are some packing parts attached on the 1399 Air Rower. Please follow the steps below to remove them before any assembly. These parts are only for packing, do not dispose of the packing materials until assembly is completed.
STEP 1
Remove the CARDBOARD ROLLER from the front of the MAIN FRAME(1) by removing the SCREWS and WASHERS.
STEP 2
A BUCKLE has been attached to the STRAP(24) to prevent the STRAP(24) from returning into the main body of the 1399 Air Rower during shipping. Remove the BUCKLE by following these steps:
1.Refer to detail view 1. Pull the STRAP(24) away from the main body about 8 inches. Use one hand to hold the STRAP(24) at position A while using the other hand to pull the STRAP(24) loop on the top of the BUCKLE to the position as shown in detail view 2.
2.Refer to detail view 2. Continue to hold the STRAP(24) at position A. Pull the STRAP(24) from position B until the STRAP(24) is completely removed from the BUCKLE. Make sure the STRAP(24) isn't twisted and let it return into the main body of the 1399 Air Rower. The STRAP(24) will hold the
HANDLEBAR(16) taut against the MAIN FRAME(1).
1. | 2. |
|
A |
| A |
Buckle | B | Buckle |
|
|
Buckle
Cardboard Roller
Screws
Washers
7