3 Attach Tent to Frame Using Frame Clips
–Attach frame clips along
the edges of tent to frame poles. (illus. 5), (illus. 6)
–Make any adjustments to the tent corner stakes that are needed.
illus. 5
Frame clips
illus. 6
Assembled tent without rainfly.
4 Attach Rainfly
– Assemble rainfly pole by
Frame ties
Pole sleeve
interlocking
– Insert rainfly pole through pole sleeve above vestibule door on the underside of rainfly. (illus. 7), (illus. 8)
– Drape rainfly over tent frame, pole side down. Rainfly pole should be over the tent door.
– Insert one end of rainfly pole end onto pin of pin & ring system, at the front tent corner. (illus. 4)
– Go to opposite end of pole and gradually apply pressure to the pole forming an arch until you are able to insert the pin into the pole.
– Connect the four elastic loops with “S” hooks, (found at the rainfly corners) to the four rings located at the end of the stake loops at the corners of the tent.
– Secure rainfly with attachments located on the underside of fly. (illus. 8)
– Stake out the tent with guylines. (illus. 8)
– Stake out front of the vestibule.
illus. 7
Insert rainfly pole piece through the pole sleeve on the underside
of the rainfly
Guyline
“S” hooks attach rings at the corners
Vestibule door may be rolled
up and secured
with toggle & loops for added
ventilation Guyline
illus. 8 Completed tent with rainfly. Note where rainfly pole sleeves, rings, and under ties are located.
Things You Should Know
•Under certain conditions (cold weather, high humidity, etc.) condensation will form on the inside surfaces of your tent. Condensation is caused by water vapor from your breath, perspiration, or any wet clothing inside your tent. It is NOT LEAKAGE through the tent fabric. It can be minimized by removing wet clothing from your tent and by providing good ventilation through the tent.
•Never store tent, even for a short period of time, without drying it thoroughly and brushing off caked dirt. Do not pack stakes or poles inside your tent. Use a separate storage bag.
•STAKES SHOULD BE REMOVED BY PULLING ON THE STAKE ITSELF. NEVER PULL ON THE TENT FABRIC OR TENT STAKE LOOP TO REMOVE STAKE.
•TENT POLES SHOULD NOT BE LEFT TELESCOPED
TOGETHER DURING STORAGE.
•Seam sealer has not been provided with your tent. For additional protection we recommend seam sealing your tent prior to camping. Seam sealer may be purchased through your local retailer or at your local sporting goods store.
•Do not leave your tent
WARNING: KEEP ALL FLAME AND HEAT SOURCES AWAY FROM THIS TENT FABRIC. This tent meets the flammability requirements of
THE COLEMAN CO., INC.
3600 N. Hydraulic • Wichita, Kansas 67219
PRINTED IN CHINA Rev. 11/05
MADE IN CHINA