Coleman 2000001200 manual Before you begin, Parts and Components, To Set Up Tent

CIQALATM TENT 12’ X 10’

Before you begin

Read all instructions before set up.

•Select a level campsite clear of rocks, branches, and other hard or sharp objects, to install your tent.

WARNING: Keep clear of overhead power lines.

•Do not set up your tent under trees.

•For best results in windy conditions, position end of tent into the wind.

•Enlist the help of at least one other person to assist you when it is time to assemble the tent.

MODEL 2000001200

Parts and Components

Description	Part Number
Main Poles, Long, Black (2)	5010000386
Ridge Pole, Gray (1)	5010000387
Back Awning Pole w/Metal Tips, Black (1)	5010000388
Front Awning Pole, Long, Black (1)	5010000389
Rainfly	5010000400

To Set Up Tent

1.Unfold tent and spread out on a clean, level surface with the door facing the desired direction.

2. Assemble the interlocking shock-corded poles (two black main tent poles and the gray ridge pole).

3. Insert both, long, black poles through sleeves in top front and center locations on tent as shown. (Fig. 1)

4. Insert the gray ridge pole through sleeve on top of tent that runs from front to back. (Fig. 1)

Long, Black,

Shock-corded

Main Poles

Gray, Shock-corded Ridge Pole

Door (Front of Tent) Fig. 1

STITCH LINE

5.	Insert metal tip on gray ridge pole into metal	Gray Ridge Pole in Front &
	grommet located at front of tent. (Fig. 2)	Back Metal Grommets
6.	Insert one end of front and center black poles
	into pins in front corner and side of tent.
	(Fig. 3 & 3A)
7.	Go to opposite end of each pole and gradually	3B
	apply pressure to the poles forming arches.	Fig. 2
	Insert the pin into the pole end at the front
	corner and side of tent. (Fig. 3)
8.	Go to back of tent and gradually apply pressure on	3A
	the gray ridge pole forming an arch; then insert metal
	tip of pole into metal grommet on web strap at
	back of tent. (Fig. 3)
9.	Stretch corners and sides of tent until floor is
	taut then hammer stakes through loops to secure.
	(Fig. 3B)	Fig. 3

To Attach Rainfly

1.Assemble long, thin, black interlocking shock-corded front awning pole.

2.Unfold rainfly. Locate the sleeve, along front edge, and the hook & loop fasteners on the underside of rainfly.

3.Drape rainfly over tent. Make sure the sleeve is centered over the door and the hook & loop fasteners, on the underside of the rain- fly, are positioned over the black main poles and gray pole. (Fig. 4)

4.Slide front awning pole through sleeve at front of the rainfly. (Fig. 4)

5.Insert one end of front awning pole into pin in front corner of tent. (Fig. 5A)

6.Go to opposite end of front awning pole and gradually apply pressure until pole forms an arch. Insert the pin into the pole end at the front corner of tent (Fig. 5 & 5B). Drive stakes through straps on vestibule flap. (Fig. 5C)

(continued on other side)

	Sleeve on Front
	of Rainfly
Door	Front Awning
	Pole
	Fig. 4

Vestibule Flap

Fig. 5

5C

5A

5B