Coleman 2000000583 Attaching Room Divider, Overhead Storage, Electrical Cord Access, To Store

Fig. 28

Fig. 19 Fig. 20

To Attach Rainfly continued

3.Insert end of Awning Pole with plastic tip into web pocket at front of the Rainfly. (Fig 15)

4.Insert metal tip on Awning Pole into hole in Long Leg Pole (Fig 16). NOTE: It may be necessary to rotate the pole slightly for proper alignment with Awning Pole.

Fig. 15 Fig. 16

5.Install remaining Awning Pole at back of tent as shown in steps 3 & 4 above. (Fig. 15 & 16)

6.Insert hooks on elastic straps, located at corners of Rainfly, into holes on the four Short Leg Poles to secure. (Fig. 17)

7.Insert hooks on long elastic straps, located at front and back of Rainfly, into holes on Long Leg Poles to secure. (Fig. 18)

Fig. 17 Fig. 18

8.Tie guylines onto the six web loops located on the sides of the Rainfly. (Fig. 19 & 21)

9.Loop end of guyline over stake, stretch tight, then hammer into ground at an

angle as shown. (Fig. 20 & 21)

10.Secure door mat

through loops with stakes. (Fig. 21)

Web Loop

Guyline

			Door Mat		Fig. 21
Attaching Room Divider
1. Divider Panel can be installed
through center of the tent by
inserting toggles through the
top and bottom fabric loops as				Divider
shown. (Fig. 22 & 23)				Panel
			Pockets for
			Gear Storage
	Fig. 22	Fig. 23
Overhead Storage
				Tent Loop

1.Hang the overhead storage panel by placing the hooks through the loops

on the inside of the tent. (Fig. 24)
NOTE: The overhead storage is to keep
	Hook on
small items off the floor. Large or	Storage
	Panel
		Fig. 24
heavy items may damage the tent.

Electrical Cord Access
1. Unzip access panel in the lower
left corner of tent and bring in
electrical cord.
NOTE: Use only UL approved cords
rated for outdoor usage. (Fig. 25)	Fig. 25
Cooler Access
The smaller zippered opening at the side
of tent is designed for added ventilation
and easy access to your beverage cooler.
1. To use as a vent, unzip flap to expose	Fig. 26
screen. (Fig. 26)
2. To use as a cooler access, unzip
other flap to make an avenue to bring
beverages into tent. (Fig. 27)
	Fig. 27

Door & Window Flaps/Vents

1.For better ventilation, unzip door flaps, roll, and insert toggle into fabric loop to secure.

2.To open back and side window vents for more ventilation, unzip, then roll up and insert toggles through fabric loops.

To Store

1.All metal poles and stakes must be placed in the storage bag to prevent damage to the fabric items placed in the carry case.

2.Make sure tent is clean and dry before placing in carry case.

3.Remove rainfly, spread out on floor of tent, then unzip door & vents before taking tent down for storage.

4.Neatly fold tent to width of pole storage bag, place on tent, roll tightly, and place in carry case.

5.Use wheels on bottom of carry case and web handle for easy transporting of the tent. (Fig. 28)

6. Store in a clean, dry area.

Things You Should Know:

•Under certain conditions (cold weather, high humidity, etc.) condensa- tion will form on the inside of your tent. Condensation is caused by water vapor from your breath, perspiration, or any wet clothing inside the tent. It is NOT LEAKAGE through the tent fabric. It can be minimized by removing wet clothing from your tent and by providing good ventila- tion through the tent.

•Never store tent, even for a short period of time, without drying it thoroughly and brushing off caked dirt. Do not pack stakes or poles inside your tent. Use a separate storage bag.

•STAKES SHOULD BE REMOVED BY PULLING ON THE STAKE ITSELF. NEVER PULL ON THE TENT TO REMOVE STAKE.

•TENT POLES SHOULD NOT BE LEFT TELESCOPED TOGETHER DURING STORAGE.

•Do not leave your tent set-up for weeks at a time. Be aware that exposure to ultraviolet rays from the sun can seriously damage material and/or cause it to become discolored.

WARNING: Keep all flame and heat sources away from this tent fabric.

This tent meets the flammability requirements of CPAI-84. The fabric may burn if left in continuous contact with any flame source. The application of any foreign substance to the tent fabric may render the flame-resistant properties ineffective.

The Coleman Company, Inc. • 3600 N. Hydraulic • Wichita, Kansas 67219

1-800-835-3278 • www.coleman.com

MADE IN CHINA • PRINTED IN CHINA

	© 2007 The Coleman Company, Inc.
Coleman® and	are registered trademarks of The Coleman Company, Inc. Rev 01/08

STITCH LINE