Rheem GEN12AD-V, Generator Systems installation manual Ction, Repro, Access Ports

Access Ports

Each generator is shipped with a set of identical keys. These keys fit the locks that secure the access ports.

To open access door:

1.Insert key into lock of access door and turn key one quarter turn counterclockwise.

2.Remove key.

To close access door:

1.Close control panel door and insert key into lock and turn key one quarter turn clockwise.

2.Remove key.

The generator is equipped with a removable roof and removable side panels to permit simple servicing.

To remove roof and divider:

To remove side panels:

1.Open the control panel access door.

2.Set generator’s circuit breaker to OFF position.

3.Set control panel system switch to OFF.

4.Remove 15 Amp fuse from control panel.

5.Remove roof and divider.

6.Lift latches (B) up on both sides of panel to release.

7.Pull panel upward and out of grooves.

B

1. Open the control panel access door.

2. Set generator’s circuit breaker to OFF position.

3. Set control panel system switch to OFF.

4. Remove 15 Amp fuse from control panel.

5. Move roof latch (A) to the left until roof pops up slightly.						CTION
		To remove					haust pane
			1.	Rem			ve roof and divider.
			2.		move side panels.
	NOT	OU
				WARNIN Contact with muffler area could cause burns
	REPRO		D		resulting in serious injury.
A
	FO		t DO NOT touch hot parts and AVOID hot exhaust gases.
			t Allow equipment to cool before touching.
6. Lift roof off generator.			3. Remove 6 screws (C) from exhaust panel.
7. Rotate 4 knobs 1/4 turn and lift divider off.
							C	C

C

C

C

C

8. Replace divider and roof in reverse order.

18