Repair and Maintenance, Charging the Battery

BEFORE RIDING

qCharging the Battery

Your electric four wheeler may not have a fully charged battery; therefore it is a good idea to charge the battery prior to use.

• Initial charge time: 12 hours	• Run time: Up to 40 minutes of continuous ride time.
• Recharge time: up to 12 hours,	Run time may vary depending on riding conditions,
depending on level of depletion.	climate and/or proper maintenance.
• Fully charge battery before storing.	• Average battery life: 250 charge/discharge cycles
• When the scooter is not in regular use,	• To ensure long battery life, do not store the battery
recharge the battery at least once a	in temperatures above 75° or below -10° F.
month until normal use is resumed.
Charger

Note: Make sure power is	1 Plug the charger into a wall	2 Turn power OFF before
turned OFF when unit is not in	outlet. If the lights on charger	charging. Plug the charger into
use. If the power switch is left	do not light up, check the power	the charger port to charge unit.
on for an extended period of	to the outlet. If necessary, try a
time, the battery may reach a	different outlet.
stage at which it will no longer
hold a charge.

Repair and Maintenance

Turn power switch OFF before conducting any maintenance procedures.

WARNING:

Rechargeable batteries are only to be charged under adult supervision. Always disconnect your electric four wheeler from the charger before cleaning with liquid.

Note: If your charger does not look like the one illustrated, your unit has been supplied with an alternative charger. The specifications and charging procedure would not change.

The charger has a small window with one LED to indicate the charge status. Refer to the illustration on the charger unit for the actual “charging” and “charged” status indications for your model charger.

Chargers have built-in over- charge protection to prevent battery from being over- charged.

Charger will get warm during use. This is normal for some chargers and is no cause for concern. If your charger does not get warm during use, it does not mean that it is not working properly.

WARNING: Failure to recharge the battery at least once a month may result in a battery that will no longer hold a charge.

qAdjusting the Brake

Tools required: 5mm Allen wrench

37- 44 mm

Rotor

Caliper adjuster

Pads

Backside

view of

disk brake

WARNING:

The brake is capable of causing the electric four wheeler

to skid the tire throwing an unsuspecting rider. Practice in an open area free from obstacles until you are familiar with the brake function. Avoid skidding to a stop as this can cause you to lose control or damage the rear tire(s).

1To adjust the tension, thread the brake lever adjuster in or out 1/4 to 1/2 turn until the desired brake adjustment is attained. Most adjustments are complete at this step. If brake still needs further adjustment, proceed to step 2 for rear brake.

2 Locate the rear brake caliper and disk brake behind the right rear wheel. The distance of the brake wire between the end of the cable and the anchor bolt should be between 37 and 44

mm.If the rear brake has too much slack, loosen the rear anchor bolt with a 5mm Allen wrench and pull the brake wire tighter (direction indicated with arrow).

3 If the brake rotor is dragging on the brake pads use your fingers to twist the caliper adjuster in either direction until rotor is centered between pads.