Saris 911 Open accessory tracks, Slide components into tracks, Tighten all parts, Load bikes

Step 2-

Open accessory tracks.

Turn knob 1/2 turn toward gray arrow (loosening rack slightly) until the word "LOCK" is upside down.

Note:

For upright clamp locking capabilities, Lock Plug Kits are available through your local Saris dealer. To complete a single key locking system, purchase the Lock Plug item number identical to the number on your Saris load bar key.

Insert Lock Plug per instructions before mounting upright arm to load bar.

Step 3-

Slide components into tracks.

A)Upright Arm

•Lift levers of upright arm.

•Align tabs with load bar accessory track.

•Slide component into track.

•Close levers.

Note: Adjustment of lever tension is preset. If component will not slide into

track, loosen tension screw between tabs. If component still slides when lever is closed, tighten tension screw.

C)Wheel Tray

•Loosen daisy dial attached to upright bracket.

•Align attachment block and upright bracket.

•Slide tray channel from back to front (along block to upright bracket). Note: Slide tray forward enough to overhang load bar approximately 12-14 inches.

•Tighten upright bracket daisy dial against wheel tray. Note: Retighten daisy dial after the first two hours of initial use.

Step 4-

Tighten all parts.

•Adjust and straighten all components.

•Close levers to hold upright arm in place.

•Secure attachment block to load bar and attachment block to wheel tray by turning daisy dials in direction of arrows.

down tube

seat tube

arrows

Step 5-

Mount additional accessories.

•Distribute bikes evenly along load bars.

•To carry 3 or more bikes, it may be necessary to alternate direction bikes face. To do so, reverse entire setup such that bikes face the opposite direction.

•Balance load evenly.

Step 6-

Load bikes.

• Lift bike and place tires in wheel tray.
(Bikes can face either direction.)	B

•Open upright clamp, fasten around seat tube with arm next to rear tire or

down tube with arm next to front tire	A
(avoiding cables).
• Rotate clamp handle enclosing
clamp around bike tube (A) and
close handle (B). Clamp should
firmly grasp bike tube.
• Align tab of wheel straps with wheel
tray channel and slide into place.
Secure both tires. Center shim
over narrow tires and remove shim
for wide tires. Thread strap through
buckle and snap buckle down to
secure .

B)Attachment Block

•Position curved side of block down against load bar with wheel tray dial toward opposite load bar.

•Align bolt head with accessory track.

•Slide block into track.

Direction of opposite load bar

Note: Upright arm can be mounted to front or rear load bar.

Note: When not in use, buckle

straps firmly or remove to prevent

loss.

Instructions continued on back...