Owners

M A N U A L

Step 2c

F R A M E A S S E M B L Y

Continue assembly by inserting (CE) into (6), then attach (10) to (CE). Wrench Tighten bolts. NOTE: Check to see that the Arm Assembly rotates freely. If not, turn back the nut on the bolt for the axle just enough so that the Arm Assembly rotates freely. Slide a (CF) onto each tube end of (10). Then install an (11) to each side capturing (CF) between (11) and Button Head Bolt

(F). Wrench Tighten bolts. Slide a (12) onto each (11). See the Assembly Note for the correct rear slot positioning of (12). Install the range limiting bolt (F) through the slots in each (12). Wrench Tighten bolts. Attach (CG) to the top of each (12). Wrench Tighten the retaining nuts then turn the nuts back just enough so that each (12) rotates freely. Now insert both (CS)’s into (9), then attach to (10) at the top and to (8) at the bottom. WARNING: when attaching

(9)to (10), take special precaution when handling the arm. If released, the front of (10) will swing up with a considerable amount of force, and could cause bodily injury. Wrench Tighten bolts. NOTE: Check to see that the Arm Assembly and the Weighted Connector rotates freely. If not, turn back the nut on the bolt for the axle just enough so that the Arm Assembly and Weighted Connector rotates freely.

Part Descriptions

6 - Front Upright

8 - Resistance Lever Arm

9 - Weighted Connector

10 - Arm

11 - Handle Assembly

12 - Bearing Housing

Hardware Descriptions

C - 1/2”-13UNC x 3 1/4” Hex Head Bolt (WZ) E - 1/2”-13UNC x 6” Hex Head Bolt (WZ)

F - 3/8”-16UNC x 3/4” Button Head Bolt (WZ) R - 3/8”-16UNC x 1” Socket Head cap Screw

AA- 1/2” Washer AB - 3/8” Washer

AE - 3/8” Lock Washer BA - 1/2” Nylok Nut

CS - 19mm dia. x 57.5mm lg. Axle CE - 25.4mm dia. x 120mm lg. Axle CF - Rubber Sleeve

CG - Aluminum Bolt on Cap

Page - 9

HD1700 Assembly