OWNERS
M A N U A L
Step 2b
F R A M E A S S E M B L Y
Continue assembly by attaching both (7)’s to (6); NOTE: when securing both (7)’s, and (5) together, slide (CT) into the holes on (7) and
(6)before securing with (B) to ensure proper alignment. (CT) acts as a spacer for a pulley which is installed in a later step.. Attach (6) to (2) and
(5).Then insert (CS) into (8) and attach (8) to (6). Wrench Tighten all bolts. NOTE: If the Resistance Lever Arm (8) does not swing freely. Turn back the nut (BA) till the arm swings freely.
Part Descriptions
2 - Top Pulley Mount
5 - Front Support
6 - Front Upright
7 - Gusset Plate
Hardware Descriptions
B -
C -
AA- 1/2” Washer BA - 1/2” Nylok Nut CA - Rubber Foot Pad
CS - 19mm dia. x 57.5mm lg. Axle CT - 11/16” Flanged Spacer
Page - 7 | HD1700 Assembly |