Razor E325S 13116390, E100 Battery Care and Disposal, Charger, Replacement Parts Repair Centers

Page 11

Repair and Maintenance

qBattery Care and Disposal

Do not store the battery in temperatures above 75° or below -10° F.

CONTAINS SEALED LEAD BATTERY. BATTERY MUST BE RECYCLED.

Disposal: Your Razor product uses sealed lead-acid batteries which must be recycled or disposed of in an environmentally sound manner. Do not dispose of a lead-acid battery in a fire. The battery may explode or leak. Do not dispose of a lead-acid battery in your regular household trash. The incineration, land filling or mixing of sealed lead-acid batteries with household trash is prohibited by law in most areas. Return exhausted batteries to a federal or state approved lead-acid battery recycler or a local seller of automotive batteries. If you live in Florida or Minnesota, it is prohibited by law to throw away lead-acid batteries in the municipal waste stream.

qCharger

The transformer/charger supplied with the scooter should be regularly examined for damage to the cord, plug, enclosure and other parts, and, in the event of such damage, the scooter must not be charged until it has been repaired

or replaced.

Use ONLY with the recommended charger.

qReplacement Parts

The most frequently requested replacement parts (wheels, tires, tubes, batteries and chargers) are available for purchase at some Razor retail partners or online at www.razorama.com. For other parts contact an authorized Razor repair center.

qRepair Centers

For a list of authorized Razor repair centers:

Check online at www.razor.com.

Send e-mail to customerservice@razorusa.com or call 866-467-2967 for the center nearest you.

10

WARNING: If a battery leak develops, avoid contact with the leaking acid and place the damaged battery in a plastic bag. Refer to the disposal instructions at left. If acid comes into contact with skin or eyes, flush with cool water for at least 15 minutes and contact a physician.

Image 11
Contents Do not Return to Store Safety Warnings ContentsRequired Tools Estimated Assembly and Set-Up TimeBefore You Begin Attaching the Handlebars Assembly and Set-UpCharging the Battery Battery that will no longer accept a chargeRiding Your Scooter Repair and MaintenanceAdjusting the Handlebar Height E100/E200/E300 only Adjusting the BrakesE150 / E200 / E300 Front Tire and E100 Tires Use the special valve Align the access holeInflating the Tires E150 / E200 / E300 Rear TireWheel alignment Adjusting the ChainTurning the wrenches counter Clockwise On the left side of the rear forkChain and Rear Tire Replacement Replace the chain guard Front Tire Replacement For a list of authorized Razor repair centers Battery Care and DisposalReplacement Parts Repair Centers ChargerTroubleshooting Guide Pads Rotor is centered between pads Mean that it is not working properlySounds Chain is too dry Brake rotor is dragging on brake E100 parts E100 parts Black folding knob Control module 03-2 6mm stem bolt E150 partsHandlebar stem/ T-bar E150 parts Quick release Kickstand Extension tube/ Folding system Speed controller w/ LEDs On/ Off switch SleeveE200 parts Bar Control module Brake lever assemble completeOnly used on E200S Headset lower Seat post Front fork E300 partsHandlebar Stem/ T-bar Control module Black folding knob 03-2 6mm stem bolt Motor 24V/ 250W Washer Kickstand WedgeOnly used on E300S SB 1918 California Declaration Page Loose Parts Tire Inflation Safety remindersWarranty Brake Safety Gear
Related manuals
Manual 11 pages 39.63 Kb Manual 13 pages 26.95 Kb Manual 13 pages 36.33 Kb Manual 12 pages 61.94 Kb