Razor E200, E100, E300 Mean that it is not working properly, Pads Rotor is centered between pads

Page 13

Troubleshooting Guide

Problem

Possible Cause

Solution

 

 

 

 

 

Sometimes the scooter

Brakes are not adjusted properly

Refer to adjusting the brakes instructions on page 4.

 

doesn’t run, but other

 

Check all wires around the motors and all connectors to make sure

 

times it does

Loose wires or connectors

 

 

 

they are tight.

 

 

 

 

 

Charger gets warm

Motor or electrical switch

Contact your local Razor authorized service center for diagnosis and

 

during use

damage

repair.

 

 

 

 

 

Scooter does not stop

Normal response to charger use

No action required. This is normal for some chargers and is no cause

 

when applying the brake

 

for concern. If your charger does not get warm during use, it does not

 

 

 

mean that it is not working properly.

 

 

 

 

 

Scooter makes loud

Brakes are not adjusted properly

Refer to adjusting the brakes instructions on page 4.

 

noises or grinding

 

Apply a lubricant such as 3 in 1TM or Tri-FlowTMto the chain.

 

sounds

Chain is too dry

 

 

Brake rotor is dragging on brake

Use your fingers to twist the caliper adjuster in either direction until

 

 

pads

rotor is centered between pads.

 

 

 

 

Need Help? Visit our web site for updates and a list of authorized service centers at www.razor.com or call toll-free at 866-467-2967Monday - Friday 8:00 AM - 5:00 PM Pacific Time.

12

Image 13
Contents Do not Return to Store Safety Warnings ContentsBefore You Begin Estimated Assembly and Set-Up TimeRequired Tools Charging the Battery Assembly and Set-UpBattery that will no longer accept a charge Attaching the HandlebarsAdjusting the Handlebar Height E100/E200/E300 only Repair and MaintenanceAdjusting the Brakes Riding Your ScooterInflating the Tires Use the special valve Align the access holeE150 / E200 / E300 Rear Tire E150 / E200 / E300 Front Tire and E100 TiresTurning the wrenches counter Adjusting the ChainClockwise On the left side of the rear fork Wheel alignmentChain and Rear Tire Replacement Replace the chain guard Front Tire Replacement Replacement Parts Repair Centers Battery Care and DisposalCharger For a list of authorized Razor repair centersTroubleshooting Guide Sounds Chain is too dry Brake rotor is dragging on brake Mean that it is not working properlyPads Rotor is centered between pads E100 parts E100 parts Handlebar stem/ T-bar E150 partsBlack folding knob Control module 03-2 6mm stem bolt E150 parts E200 parts Speed controller w/ LEDs On/ Off switch SleeveBar Control module Brake lever assemble complete Quick release Kickstand Extension tube/ Folding systemOnly used on E200S Handlebar Stem/ T-bar Control module Black folding knob E300 parts03-2 6mm stem bolt Motor 24V/ 250W Washer Kickstand Wedge Headset lower Seat post Front forkOnly used on E300S SB 1918 California Declaration Page Warranty Safety remindersBrake Safety Gear Loose Parts Tire Inflation
Related manuals
Manual 11 pages 39.63 Kb Manual 13 pages 26.95 Kb Manual 13 pages 36.33 Kb Manual 12 pages 61.94 Kb