Honeywell op10 manual Federal Communications Commission FCC Part 15 Statement, CE Certification

Page 3

FEDERAL COMMUNICATIONS COMMISSION (FCC) Part 15 STATEMENT

This equipment has been tested to FCC requirements and has been found acceptable for use. The FCC requires the following statement for your information:

This equipment generates and uses radio frequency energy and if not installed and used properly, that is, in strict accordance with the manufacturer's instructions, may cause interference to radio and television reception. It has been type tested and found to comply with the limits for a Class B computing device in accordance with the specifications in Part 15 of FCC Rules, which are designed to provide reasonable protection against such interference in a residential installation. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

If using an indoor antenna, have a quality outdoor antenna installed.

Reorient the receiving antenna until interference is reduced or eliminated.

Move the radio or television receiver away from the receiver/control.

Move the antenna leads away from any wire runs to the receiver/control.

Plug the receiver/control into a different outlet so that it and the radio or television receiver are on different branch circuits.

If necessary, the user should consult the dealer or an experienced radio/television technician for additional suggestions. The user or master may find the following booklet prepared by the Federal Communications Commission helpful:

"Interference Handbook"

This booklet is available from the U.S. Government Printing Office, Washington, DC 20402.

The user shall not make any changes or modifications to the equipment unless authorized by the Installation Instructions or User's Manual. Unauthorized changes or modifications could void the user's authority to operate the equipment.

CE CERTIFICATION

DECLARATION OF CONFORMITY TO COUNCIL DIRECTIVE 89/336/EEC

Standards to which conformity is declared:

ETS 300 683, ETS 300 330 harmonized standard, low power emitters

EN 50130-4:1998 Product family standard: Immunity requirements for components of fire, intruder and social alarm systems

Issued by:

ADEMCO, 165 Eileen Way, Syosset NY 11791

 

Tel: (516) 921-6704

 

www.ademco.com

Date of issue:

4-January-2001

Equipment type: Access Control Proximity Reader

Model numbers

OP10, OP20, OP30, OP40, OP45, and OP90

File No.

BP9666

Acknowledgements:

OmniProx is a registered trademark of Honeywell International.

Wiegand is a licensed trademark of HID Corp.

HID is a licensed trademark of HID Corp.

-3-

Image 3
Contents HOW to Mount the Reader HOW to Connect the Reader to the HostTo surface mount the reader, perform the following Distance Gage Conductor Wire Gage SpecificationsHOW to Test and Operate the Reader SpecificationsCE Certification Federal Communications Commission FCC Part 15 StatementEileen Way, Syosset, New York Ademco Limited Warranty