Using the Shot BLAST* Weapon Accessory

USING THE SHOT BLAST™* WEAPON ACCESSORY

		3.
	Note: Tags fired by the
	SHOT BLAST accessory	4.
	have a shorter range than	4.
	have a shorter range than
	regular tags, but affect a
	wider area. If you catch	5.
	several opponents standing

	close to one another, you	6.
	can actually hit all of them	6.
	can actually hit all of them
	at once!

Slide the SHOT BLAST accessory onto the front of the Tagger until it snaps into place.

To arm the SHOT BLAST, slide the Rack toward you, and then forward again.

When you pull the trigger, your Tagger will fire an extra-powerful blast. Depending on how accurate your shot is, you could take as many asthree points off your target’s Strength Gauge.

You will need to Rack the SHOT BLAST again before you can fire it.

If you pull the Trigger without using the Rack, you will fire a single, regular Tagger shot.

To remove the SHOT BLAST, slide the Release Button down and pull it off the Tagger.

USING THE PINPOINT SIGHT

1. Slide the PINPOINT SIGHT onto the accessory rail on the top of your Tagger until it locks into place.

2. Look into the PINPOINT SIGHT. If it is properly attached, you will see a green dot reflected on the crosshairs.

3. Line up the green dot in the center of the crosshairs with your target for pinpoint accuracy!