STEP 2 ORANGE BAG
• Attach the connecting brace (1a) to the empty holes on the left floor support of the base unit (ST200). Connect with two carriage bolts (M10x1.5Px60L), two flat (10.5x18x2T) & spring (SW10.2x18.4x2.5T) washers, and two nuts (M10x1.5P). Attach the opposite end of the connecting brace to the main floor support (1b) of the leg press. Attach the two bolts already in (1b) with two flat (10.5x18x2T) & spring (SW10.2x18.4x2.5T) washers, and two nuts (M10x1.5P). Tighten all four nuts with a 17mm wrench.
|
|
| • Slide the rear vertical support (1c) |
|
|
| over the top of the protruding bolts on |
|
|
| the rear floor support (1d). Loosely |
|
|
| fasten two flat (10.5x18x2T) & spring |
|
|
| (SW10.2x18.4x2.5T) washers and two |
|
|
| nuts (M10x1.5P) to the bolt ends. |
|
|
| Slide this structure and mate with the |
|
|
| bolts attached to the rear of 1b. |
|
|
| Loosely attach two flat (10.5x18x2T) & |
|
|
| spring (SW10.2x18.4x2.5T) washers |
|
|
| and two nuts (M10x1.5P). Attach the |
|
|
| side supports (1e) to the sides of 1b & 1c. |
|
|
| Fasten with four bolts (M10x1.5Px100L), |
|
|
| eight flat (10.5x18x2T) washers,and |
|
|
| four nuts (M10x1.5P) using a 6mm L- |
1e |
|
| shaped wrench and a 17mm wrench. |
| 1c | Securely tighten all fasteners. | |
| 1e | ||
|
| ||
|
|
|
1d
1a
1b
9