Blue BAG

STEP 3

•Lay the seatback (2a) face down. Mate the seatback support (2b) to 2a. Make sure the holes of 2b are pointing up towards the top of the seatback. Securely fasten four bolts (M10x1.5Px30L) into the seatback using a 6mm L-shaped wrench. Thread the pull pin partially into the opening of 1b. Guide the seatback into the oval opening at the rear of the main support tube (1b). Pull up and hold the pull pin, while you guide the seatback in the rest of the way. Release the pull pin and allow to engage in one of the holes.

•Bring the handle bars (2c) up to the

bottom of the rectangular seat support plate of 1b. Place a bolt (M10x1.5Px105L) and a flat (10.5x18x2T) washer horizontally through the seat support tube of 1b. Attach a flat (10.5x18x2T) washer and a nut (M6x1P). Leave loose.

•Drop 2 bolts (M10x1.5Px50L) vertically through the seat support tube of 1b. Attach two flat (10.5x18x2T) washers and two nuts (M10x1.5P). Tighten using a 6mm L-shaped wrench and a 17mm wrench. Tight the horizontal hardware with a 10mm wrench and a 4mm L-shaped wrench.

•Lay the seat (2d) on top of the flat steel support of 1a. Make sure the rounded part of the seat is pointed towards the front. Securely fasten four bolts (M10x1.5Px30L) up into the seat using a 6mm L-shaped wrench.