3 Diagnostic Programs

3.11Error Codes and Description

 

 

 

The test pattern read out from the

 

 

04

(XMS)Memory Problem

extension memory is different

As above.

 

from the one that has been

 

 

 

written in this address.

 

 

 

 

 

 

 

05

(XMS) Out Of Range

Wrong parameters setup.

Check and reset the parameters.

 

06

Address Test Error

Interference between different

Test this memory chip on

 

address channels.

multiple machines.

 

 

 

 

07

Toggle Bit Error

Errors with the timer chip.

As above.

 

08

Interval Error

The acquired refreshing

Reset the estimated range.

 

frequency is out of the estimated

 

 

 

range.

 

 

 

 

The pattern read out from the L1

 

 

09

L1 Cache test Error

Cache is different from the one

Test this unit on multiple

 

that has been written in the same

machines.

 

 

 

 

 

 

address.

 

 

 

 

 

 

 

12

Data Bus Error

Interference between different

As above.

 

data channels.

 

 

 

 

 

14

Speed Error

Failure during the transfer speed

As above.

 

 

 

test.

 

03xx

 

Board

 

Repeat multiple times. Whether

 

01

DMA Test Error

DMA channel cannot transfer

 

there is always the same error,

 

data normally.

 

 

 

replace the board.

 

 

 

 

 

 

 

The difference between the

 

 

 

 

actual precision of the interval

 

 

04

Interval Timer Error

timer and its theory value is out

As above.

 

 

 

of the permitted range. The timer

 

 

 

 

counts imprecisely.

 

 

 

 

 

 

 

05

Periodic Faster Error

The frequency is beyond the

As above.

 

standard.

 

 

 

 

 

06

Periodic Slower Error

The frequency is below the

As above.

 

standard.

 

 

 

 

 

07

Update-ended Interrupt

R/W errors with the RTC

As above.

 

Error

refreshing interrupt controller.

 

 

 

 

 

 

The PC speaker's sound source --

 

 

08

RTC Alarm Error

-counter/timer 8253 cannot

As above.

 

produce corresponding timing

 

 

 

 

 

 

 

signal.

 

 

 

 

 

 

 

13

PCI Bus Error

No PCI.

Check the board.

 

14

PCI Bus Scan Error

PCI test fails.

As above.

 

15

PCI Device Access Error

PCI access fails.

As above.

 

16

PCI Config Verification

Wrong PCI configuration.

Check PCI configuration on main

 

Error

board or PCI Device

 

 

 

64Satellite E100 Maintenance Manual

Page 131
Image 131
Toshiba SATELLITE E105 manual Diagnostic Programs 11Error Codes and Description, 03xx Board