Cateye CC-AT100 manual Auto Automatic Start/Stop Function, Mounting Main Unit, Test

Bracket Bracket

E

Wire

Rubber Pad

Fig.21

Wire Securing

Tape

SlideLever

Speed Sensor

Fig.20

Front

Fig.22

•Secure the wire with the wire securing tape as in Fig. 20. Wind the wire round the outer cable up to the handlebar. When ad- justing the length, be careful that the wire will not hinder handle- bar operation.

•By using the rubber pad, attach the bracket close to the handle- bar stem (Fig. 21).

Mounting Main Unit

Slide the main unit onto the bracket from front until it clicks into position. The contacts will automatically connect. To remove the unit, pull it off forward while pushing down the lever (Fig. 22).

Test

Mount the main unit. Spin the wheel to check if the display shows the speed. If not, adjust the relative positions of the magnet and the sensor again following the instructions.

2. Auto (Automatic Start/Stop) Function

This function enables the unit to start/stop automatically without operation of the S/S button. In this function, AT sym- bol appears on the screen (Fig. 23). It starts measuring automatically even when the power-saving function is on.

• In this function, it starts/stops by perceiving revolutions of the wheel, so it stops measuring when the wheel ceases

AT

moving.

Fig.23

12

•While this function is on, 2 seconds may be elapsed at the moment when the main unit is mounted onto the bracket.

•When using this unit on its own apart from bicycle, switch off this function. Operation of the S/S button is needed.

How to Switch on/off Auto Function

Operate the mode button to display the main mode showing T, D or A. Get the stop state by pressing the Set button; then AT symbol appears and the Auto function is on. To switch this function off, press the Set button again and AT symbol disappears.