Cateye CC-AT100 manual Main Mode SUB Mode

		• Each main mode has its respective sub mode. To switch to the sub mode, hold down this button. To
E	B		switch back to the main mode from the sub mode, just press this button ordinarily. To shift from one
			mode to another, it is necessary to switch back to the main mode (from the sub mode) each time.
D	C		B S/S (Start/Stop) Button (Upper Button)
		•	With each press, this button starts or stops measuring trip distance (D), elapsed time (T) and
			average speed (A). During operation, the speed scale symbol or temperature scale symbol
			flashes.
		•	In the Auto (automatic start/stop) function [when AT symbol is on], this button does not work (refer
	A		to page 12).
			C Light Button (Right Side Button)
Fig.8

• With each press, the display is backlit for approx. 3 seconds.

How the mode shifts by the MODE button

MAIN MODE			SUB MODE
	Current Speed		Trip Alt.Gain
		Current	x1000	Total
		Altitude		Alt.Gain
	Current Speed		Current Speed
	T	Elapsed		12-Hour
		Time		Clock
	Current Speed		Current Speed
	A	Average	M	Max.
		Speed		Speed
	Current Speed		° C/° F Temp.
	D	DistanceTrip	O	DistanceTotal

Press ordinarily

Fig.9

Hold down

DSet Button (Left Side Button)

This button is used for the following operations:

•For correcting the current altitude

	press this button in the	mode (but only when the current speed is zero) ----	refer to page 10
•	For shifting the altitude measuring mode
	press this button in the total altitude and the trip altitude gain mode ----------------		refer to page 10
•	For switching on/off the Auto (automatic start/stop) function
	press this button in T, D or A mode (but only in complete stop state) --------------		refer to page 12

•For changing the wheel circumference

press this button in O (total distance) mode (but only when the current speed is zero)

---------------------------------------------------------------------------------------------------------	refer to page 7
• For setting clock time
press this button in the clock time mode (but only when the current speed is zero) ----	refer to page 7

AC (All Clear) Button (on the back)

This button erases the data stored in memory. Press this button when setting up the unit for bicycle for the first time, or when irregular display occurs. After pressing this AC button, all displays illumi- nate and then only the "km/h" symbol appears. The accumulated data (total distance and total alti- tude gain) and the stored wheel circumference are not deleted by this operation. After this operation, only the speed scale, temperature scale and clock time must be set again, according to "Main Unit Preparation" (refer to page 7).

8