JVC MX-J333VU manual Common Operations

English

Common Operations

Setting the Clock

Before operating the unit any further, first set the clock built in this unit.

1	Press PANEL OPEN/CLOSE 5.	PANEL
		OPEN / CLOSE
	The unit is turned on and the Powered Rolling Panel
	opens automatically.
2	Press TIMER/CLOCK h.	TIMER
		/CLOCK

The hour digits start flashing on the display.

PRESET

3 Press 4 ; or ¢ ; to adjust the PREV NEXT hour, then press SET k.

Setting the AM Tuner Interval Spacing

Some countries space AM stations 9 kHz apart, and some countries use 10 kHz spacing.

On the unit ONLY:

You can only change the AM tuner interval spacing while tuning into an AM station.

Press FM/AM u, + while holding down 7 z, _.

•Each time you press the button, the AM tuner interval spacing alternates between 9 kHz and 10 kHz.

FM/ AM

NOTE: Preset memory lost when the interval spacing is changed.

Turning On the Power and Selecting the Sources

• If you want to correct the hour after pressing SET k, press CANCEL /. The hour digits start flashing again.

SET

When you press the play button for a particular source (FM/AM, CD 6, AUX, and TAPE 23), the unit turns on, and the Powered Rolling Panel opens automatically (and the unit starts playing the source if it is ready — COMPU PLAY CONTROL).

PRESET

4 Press 4 ; or ¢ ; to adjust the PREV NEXT minute, then press SET k.

To listen to the FM/AM broadcasts, press FM/AM u, +. (See

page 16.)

To check the clock time

SET

DISPLAY

To play back CDs, press CD 6y, ). (See pages 9 – 11.) To play back tapes, press TAPE 2 3 7, -. (See page 17.) To select the external equipment as the source, press AUX p, ~.

Press DISPLAY c while playing any source.

•Each time you press the button, the source indiction and the clock time alternate on the display

To adjust the clock again

If you have adjusted the clock before, you need to press TIMER/ CLOCK h repeatedly until the clock setting mode is selected.

•Each time you press the button, the timer/clock setting modes change as follows:

DAILY ON TIME REC

Cancelled Clock ON TIME setting

(The hour digits start flashing.)

When you unplug the AC power cord or if a power failure occurs

The clock is reset to “0:00” right away, while the tuner preset stations (see page 16) will be erased in a few days.

FM/ AM CD TAPE AUX

To turn on the unit without playing, press 2, STANDBY

!so that the STANDBY lamp goes off.

The Powered Rolling Panel opens automatically.

To turn off the unit (on standby), press	2, ! STANDBY
again so that the STANDBY lamp lights up.
The Powered Rolling Panel also closes.

A little power is always consumed even while the unit is on standby.

To switch off the power supply completely, unplug the AC power cord from the AC outlet.

When select CD source, "LOADING" indicates on the display for a few seconds.

During the LOADING indication, the unit will initialize for preparing to play CD.

7 Continued

EN6-16;MX-J333V/PM67

6/30/99, 2:26 PM