JVC MX-J333VU Recording, Press REC START/STOP s, To clean the heads, capstants and pinch rollers

Recording

IMPORTANT:

•It may be unlawful to record or play back copyrighted material without the consent of the copyright owner.

•The recording level is automatically set correctly, so it is not affected by the VOLUME control. Thus, during recording you can adjust the sound you are actually listening to without affecting the recording level.

•While recording, you can hear sound modes and/or the Active Bass Extension effect through the speaker or headphones. However, the sound is recorded without these effect (see page 8).

•If recording you have made have excesssive noise or static, the unit may be too close to a TV. Increase the distance between the TV and the unit.

•You can use type I and II tapes for recording.

To protect your recording Cassettes have two small tabs on

the back to protect unexpected erasure or re-recording.

To protect your recording, remove these tabs.

To re-record on a protected tape, cover the holes with adhesive tape. When using type II tape, be careful not to cover the holes used to detect the tape type.

To keep the best recording and playback sound quality

If the heads, capstant, and pinch rollers of the cassette decks become dirty, the following will occur:

• Impaired sound quality

• Discontinuous sound

• Fading

• Incomplete erasure

Recording Tapes on Deck B

1 Press EJECT 0o for the deck B.

2 Put in a recordable cassette, with the exposed part of the tape down.

3 Close the cassette holder gently.

4 Check the tape direction of deck B.

•If the tape direction is not correct, press TAPE 2 3 7, - twice then 7 z, _ to change the tape direction.

5 Start playing the source — FM, AM*, CD player, deck A or auxiliary equipment connected to AUX jacks.

•When the source is CD, you can also use CD Direct Recording. (see page 19.)

•When the source is deck A, you can also use the dubbing method. (See “Dubbing Tapes” on page 19.)

* See “To record an AM station — Beat Cut” on page 19.

English

• Difficulty in recording

To clean the heads, capstants and pinch rollers

Use a cotton swab moistened with alcohol.

Pinch rollers

Capstans

Heads

To demagnetize the heads

6 Start recording. On the unit:

Press REC START/STOP s.

The indicator lights up on the display and recording starts.

On the remote control:

1)Press REC PAUSE 8.

The indicator starts flashing on the display.

2)Press TAPE 2 3 - .

The indicator stops flashing and remains lit, and recording starts.

To stop during recording, press REC START/STOP (or 7 _ on the remote control).

REC

START/STOP

REC PAUSE

sagain

Turn off the unit, and use a head demagnetizer (available at electronics and record shops).

To stop recording temporarily (except when the playback

source is deck A), press REC PAUSE 8 on the	REC PAUSE
remote control.
To resume recording, press TAPE 2 3 7, -.

To remove the cassette, press EJECT 0 o for deck B.

18 Continued

EN18-21;MX-J333V/PM618

6/30/99, 2:24 PM