S E M B LY 3T Assembly, Unpacking, Parts

INTRODUCTION

A S S E M B LY

1. 3T ASSEMBLY

INTRODUCTION

IMPORTANT PRECAUTIONS

ASSEMBLY

BEFORE YOU BEGIN

TREADMILL OPERATION

CONDITIONING TROUBLESHOOTING GUIDELINES &

IMPORTANT: READ THESE SAFETY INSTRUCTIONS BEFORE USE!

WARNING

During the assembly process of the treadmill there are several areas that special attention must be paid. It is very important to follow the assembly instructions correctly and to make sure all parts are firmly tightened. If the assembly instructions are not followed correctly, the treadmill could have frame parts that are not tightened and will seem loose and may cause irritating noises. There should be no side-to-side play in the console masts or any forward and back play in the console assembly or handlebars. If there is any play in these areas, the treadmill has not been properly assembled. To prevent damage to the treadmill, the assembly instructions must be reviewed and corrective actions should be taken.

UNPACKING

Place the treadmill carton on a level flat surface. It is recommended that you place a protective covering on your floor. Take CAUTION when handling and transporting this unit. Never open box when it is on its side. Once the banding straps have been removed, do not lift or transport this unit unless it is fully assembled and in the upright folded position, with the lock latch secure. Unpack the unit where it will be used. The enclosed treadmill is equipped with high-pressure shocks and may spring open if mishandled. Never grab hold of any portion of the incline frame and attempt to lift or move the treadmill. FAILURE TO FOLLOW THESE INSTRUCTIONS COULD RESULT IN INJURY!

Before proceeding, find your treadmill’s serial number and model name located to the left of the on/off power switch and power cord and enter it in the space provided below.

enter your serial number and model name in the boxes below:

SERIAL NUMBER:

WATER BOTTLE HOLDER

SAFETY KEY PLACEMENT

DISPLAY

CONSOLE MAST COVER

CIRCUIT BREAKER

ON/OFF SWITCH

POWER CORD

CONSOLE MAST

TRANSPORT WHEEL

PARTS

1 Console Assembly

1 Power Cord

1 Safety Key

2 Water Bottle Holders

3 Hardware Bags

Left and right outer Console Mast Covers

CONSOLE

TOUCH PAD

GRIP PULSE HANDLE BARS

MOTOR COVER

SIDE RAIL

ROLLER END CAP

REAR ROLLER

ADJUSTMENT BOLTS

RUNNING BELT

TOOLS (INCLUDED)

5mm Allen Wrench

Flat Wrench 6mm T-Wrench

IMPORTANT PRECAUTIONS

ASSEMBLY

BEFORE YOU BEGIN

TREADMILL OPERATION

TROUBLESHOOTING CONDITIONING MAINTENANCE GUIDELINES

LIMITED

MAINTENANCE WARRANTY

MODEL NAME:

*Refer to the serial number and model name when calling for service.

*Also enter this serial number on your Warranty Card.

NOTE: It is recommended that you apply grease to the threads of each bolt as you assemble your treadmill, to prevent loosening and noise. Also, during each assembly step, ensure that ALL nuts and bolts are in place and partially threaded in before completely tightening any ONE bolt.

If you have questions or if there are any missing parts, contact Customer Tech Support.

Contact information is located on the back panel of this manual.

For a complete exploded diagram, visit us at www.horizonﬁtness.com

LIMITED WARRANTY &

1.3T_Rev.1.4.indd 6-7

7/12/06 8:25:01 AM