Assembly
Assembly requires the included Allen wrench and your own Phillips screwdriver.
Do not plug in the power cord until all assembly steps are completed.
1. With the treadmill deck in the down posi- tion, leave the unit on the original pack- ing material to assemble all parts. Refer to Figure 1.
Figure 1: Deck in Down Position
2.Install Left Upright to base using four Allen Bolts M8*15mm (#27) and four Arc Washers (#41). Hand tighten all hardware at this time.
Repeat for Right Upright . Refer to Figure 2.
Note: Be careful not to pinch the wire har- ness.
Figure 2: Left and Right Upright Installation
3.Use the drag line to pull Console Wire Harness thru the top rail as shown in Figure
3.Place the grommet over the Console Wire Harness and install the grommet in the top rail.
Note: Be careful not to pinch the wire har- ness.
DRAG LINE
GROMMET
Figure 3: Top Rail Grommet Assembly
6