Assembly Instructions

KEYS treadmills are shipped in one piece to make assembly easy. After opening the box, remove any packing materials from the treadmill. You should find a rear endcap (large plastic piece that fits over the rear roller area), and owner’s manual packet with bolts and screws for assembly. Do not throw away any packing materials until the unit is working properly. Place the base on a clean, level surface. Make sure the electrical cord will easily reach an electrical outlet.

Figure 1 – Assembly for main uprights

1)Have a second person raise the console to the upright position and hold.

2)Insert 3/4” Button Head Bolt into upright bracket and tighten loosely. Repeat for opposite side.

3)Insert the TUBE SPACER inside the upright frame and line up with the bottom hole. Hold tube spacer while inserting the 1 1/2” Button Head Bolt and lightly tighten. Repeat for opposite side.

4)After completing opposite side, tighten all four assembled bolts and the two other button head bolts that were present before starting. Assembly is now complete.

5)Be sure to insert the SAFETY KEY before turning the power on.

Figure 2 – Assembly for rear end cap

To attach the rear end cap:

1)Place plastic rear end cap over exposed rear roller area.

2)Align holes in plastic end cap with pre-drilled holes in frame.

3)Loosely tighten each screw until all four screws are lined up.

4)Tighten all four screws snugly.

CAUTION: DO NOT OPERATE TREADMILL WITHOUT SECURING REAR ROLLER HOUSING!!!

Be sure the treadmill is level to the floor. The rear feet can be adjusted to level the treadmill. Assembly is now complete!

Figure 1	Figure 2

PAGE 7