11.Cover the Upright Wire (42) with the Right Grip Plate (36). Be careful not to pinch the Upright Wire. Tighten two 1/2” Screws (48) and a 3/4” Screw (2) into the Right Grip Plate and the Console Base (47).
12.Carefully lower the Left and Right Handrails (71, 72) until they are touching the floor.
11 | 47 |
| 42 |
| 36 |
| 2 |
| 48 |
12 |
|
| 107, 108 |
See the lower drawing. Position the Uprights (107, 108) so that the treadmill Frame (86) is centered between the Uprights.
Firmly tighten the two 1” Upright Bolts (21) and the two 3” Upright Bolts (76) used in steps 1 and 4.
71, 72
76
21
13.Attach the Latch Housing (29) to the Left Upright (7) with two 3/4” Screws (2). Make sure that the large hole in the Latch Housing is on the side shown.
Remove the knob from the pin. Make sure that the col- lar and the spring are on the pin as shown. Then, in- sert the pin into the Latch Housing (29), and tighten the knob back onto the pin.
Top View
108 | 107 |
86
13
|
| 7 |
Knob | 29 | Large |
| ||
| Hole | |
|
| |
2 |
| Collar |
| Spring |
|
|
| Pin |
14.Make sure that all parts are properly tightened before you use the treadmill. Note: Extra hardware may be included. Keep the included allen wrenches in a secure place; the large allen wrench is used to adjust the walking belt (see page 20). To protect the floor or carpet, place a mat under the treadmill.
10