HOW to USE a Preset Program

Current Period

1 Insert the key into the console.

See HOW TO TURN ON THE POWER on page 13.

2 Select a preset program.

To select a preset pro-

gram, press the Program Select button repeatedly until “P–1,” “P–2,” “P–3,” or “P–4” appears in the display.

When a preset program is selected, the maximum incline setting of the program and the maximum speed setting of the program will flash in the dis- play for a few seconds. The display will then show how long the program will last. A profile of the speed settings of the program will scroll across the matrix in the upper right corner of the display.

3 Press the Start button to start the program.

A moment after the button is pressed, the tread- mill will automatically adjust to the first speed and incline settings of the program. Hold the handrails and begin walking.

Each program is divided into 30 one-minute peri- ods. One speed setting and one incline setting are programmed for each period. Note: The same speed setting and/or incline setting may be pro- grammed for two or more consecutive periods.

The speed setting for

the first period will be shown in the flashing

Current Period column of the matrix. (The in- cline settings are not

shown in the matrix.) The speed settings for the next four periods will be shown in the columns to the right.

When only three seconds remain in the first period of the program, both the Current Period column and the column to the right will flash and a series of tones will sound. If the speed and/or incline of the treadmill is about to change, the speed setting and/or the incline setting will flash in the display to alert you.

When the first period is completed, all speed set- tings will move one column to the left. The speed setting for the second period will then be shown in the flashing Current Period column and the tread- mill will automatically adjust to the speed and in- cline settings for the second period. Note: If all five of the indicators in the Current Period column are lit, the speed settings may move downward so that only the highest indicators appear in the matrix.

The program will continue in this way until the speed setting for the last period is shown in the Current Period column and the last period ends. The walking belt will then slow to a stop.

If the speed or incline setting for the current period is too high or too low, you can manually override the setting by pressing the Speed or Incline buttons. Every few times a Speed button is pressed, an additional indicator will appear or dis- appear in the Current Period column; if any of the columns to the right of the Current Period column have the same number of lit indicators as the Current Period column, an additional indicator may appear or disappear in those columns as well. Important: When the current period of the program ends, the treadmill will automatically adjust to the speed and incline settings for the next period.

To stop the program at any time, press the Stop button. The time will begin to flash in the display. To restart the program, press the Start button. The walking belt will begin to move at 1 mph. When the next period of the program begins, the treadmill will automatically adjust to the speed and incline set- tings for the next period.

4 Follow your progress with the display.

See step 5 on pages 13 and 14.

5 Measure your heart rate if desired.

See step 6 on page 14.

6 Turn on the fan if desired.

See step 7 on page 14.

When you are finished exercising, remove the

7 key from the console.

See step 8 on page 14.