Image IMTL515041 specification

2.Attach the six Base Pads (100) (only three are shown) to the bottom of the Base (109) with six 3/4” Tek Screws (47). Note: The 3/4” Tek Screws are found in part bag C.

3.With the help of another person, raise the Right Upright

(82)and the Left Upright (not shown) to the vertical posi- tion. Hold the Crossbar (90) between the Uprights, and align the notches in the Crossbar with the indicated welds on the Uprights. Attach each end of the Crossbar with a 3/8” x 3 1/2” Bolt (81) and a Crossbar Endcap (84) (only the right side is shown). Make sure that the

Crossbar Endcaps are turned so the notches are aligned with the welds on the Uprights. Do not tighten the Bolts yet.

4.Turn the Console Base (85) upside-down; be careful not to scratch the Console Base. Remove the bands and the Console Back (not shown) from the Console Base. Hold the ends of the Pulse Bar (110) against the Console Frame (7) as shown. Note: The Pulse Bar Screws (68) may be preattached and may need to be removed. Connect the Pulse Wire (118) in the Console Base to the pulse wire in the Pulse Bar (see the inset drawing). The connectors should slide together easily and snap into place. If the connectors do not slide together easily and snap into place, turn one connector and try to con- nect them again.

Open part bag B. Have another person hold the Pulse Bar (110) firmly against the Console Frame (7). Attach the Pulse Bar with four Pulse Bar Screws (68) (only two are shown). Firmly tighten the Screws. Be careful not to damage the wires.

Attach the ring on the ground wire to the Console Frame

(7)with a 1/2” Ground Screw (36). Note: There are no wires on the other side of the Pulse Bar (110).

2
100		100	47
100
47
		109
100
47
3
90
	82
	84
Notch		81
		81
Welds
Notch
4
110	68	36
110		36
85			7
			7
118
Ground
Wire
118