5.Attach the Console Back (95) to the console assembly with five 3/4” Screws (6).
6.With the help of another person, hold the console as- sembly near the Right Upright (82) and the Left Upright (not shown).
Connect the Wire Harness (83) to the wire harness in the console assembly. Make sure to connect the con- nectors properly (see the inset drawing); the con- nectors should slide together easily and snap into place. If the connectors do not slide together easily and snap into place, turn one connector and try to connect them again. IF THE CONNECTORS ARE NOT CON-
NECTED PROPERLY, THE CONSOLE MAY BE DAM- AGED WHEN THE POWER IS TURNED ON. Insert the wire harnesses down into the Right Upright (82).
Set the console assembly on the Right Upright (82) and the Left Upright (not shown). Thread two 1” Bolts (71) with 1/4” Star Washers (92) into each side of the console assembly. After you have started all four Bolts, tighten them.
7.With the help of another person, lower the console as- sembly (not shown) to the floor. Have the other person hold the treadmill steady during this step.
Insert the two Wheels (108) into the Wheel Housings (106). Insert the Wheel Housings and the Wheels into the Base (109) as shown. (Note: It may be helpful to use a rubber mallet to fully insert the Wheel Housings.) Open part bag C. Attach each Wheel Housing to the Base with a Wheel Bolt (107) and a Wheel Nut (21) as shown.
Do not overtighten the Wheel Bolts.
Center the Frame (54) between the Uprights (69, 82). Tighten the four 5/16” x 3 1/2” Bolts (93). Then, raise the Uprights back to the vertical position.
5 | Console Assembly |
| ||
|
| |||
|
|
| 6 |
|
| 6 | 95 | 6 |
|
|
|
| ||
|
|
|
| |
6 |
|
|
|
|
| Console |
|
| |
| Assembly |
|
| |
|
|
|
| 83 |
|
|
|
| 92 |
|
| 82 |
| 71 |
|
|
|
| |
| 83 |
|
|
|
7 |
| 69 | 106 | 108 |
|
| 107 | ||
54 |
|
| ||
|
|
| ||
|
| 21 |
| |
|
|
|
| |
106 | 108 |
|
|
|
|
|
|
| |
|
|
|
| 93 |
|
|
|
| 109 |
82 |
|
|
|
|
93 |
|
|
|
|
8