Image IMTL94106.2 specs

3.With the help of a second person, raise the treadmill Frame (55). Hold the Latch Housing (68) and the Latch Housing Cover (5) against the sides of the Frame as shown. Loosely thread the two blunt-tipped 1/2” Screws (132) into the Latch Housing Cover and the Latch Housing as shown. Do not tighten the Screws yet.

Remove the knob from the pin. Make sure that the collar and the spring are on the pin. The collar should be on the side of the spring shown. Insert the pin into the Latch Housing (68), and tighten the knob back onto it.

Align the pin with the hole in the Left Handgrip (3) by slid- ing the Latch Housing (68) up or down. Make sure that the pin can be inserted fully into the hole. Hold the Latch Housing in place as you tighten two 1/2” Tek Screws (114) into the Latch Housing and the Frame (55). Then, tighten the 1/2” Screws (132). Note: It may be necessary to pull on the knob to access and tighten the Screws.

4.Note the location of the 75 ohm terminal near the power cord. For the television to operate properly, a CATV cable must be connected to the 75 ohm terminal (see page 9).

	3
	Hole	Knob
	3	132
	3	5
	68	5
	68
	114	Small
	Collar	Holes
	Collar
		55
	Spring
	Pin
	132	114
	4

75 Ohm Terminal

5.Make sure that all parts are properly tightened before you use the treadmill. Place a mat beneath the treadmill to protect the floor or carpet. Note: Extra hardware may be included. Keep the included hex key in a secure place; the hex key is used to adjust the walking belt (see pages 23 and 24). For your benefit, we recommend that you familiarize yourself with the TROUBLESHOOTING section on pages 23 and 24.