JVC MX-J900 manual Using the Timers, Using Daily Timer

Using the Timers

Continued

There are three timers available — Recording Timer, Daily Timer, and Sleep Timer.

Before using the timers, you need to set the clock built in the unit. (See page 9.)

Using Daily Timer

With Daily Timer, you can wake to your favorite music or radio program.

How Daily Timer actually works

The unit automatically turns on, set the volume level to the preset level, and starts playing the specified source when the

on-time comes (the indicator flashes just before the on- time, and continues flashing while the timer is operating). Then, when the off-time comes (“OFF” flashes just before the off-time), the unit automatically turns off (stands by).

The timer setting remains in memory until you change it.

•There is a time limit in doing the following steps. If the setting is canceled before you finish, start from step 1 again.

•If you have made a mistake while setting timer, press CANCEL. (However, this does not always work. If CANCEL does not work, press CLOCK/TIMER repeatedly and start from step 1 again.)

Before you start...

•When using a CD as the source to play, make sure there is a CD on the selected disc number tray.

•When using a tape as the source to play —

–Make sure that a tape is in the deck whose deck indicator (A or B) is lit on the display.

–Make sure that the tape direction is correct.

•When using the external component as the source to play, set the timer equipped with the external component at the same time.

On the unit ONLY:

1 Press CLOCK/TIMER until “DAILY” appears on the display.

The DAILY (Daily Timer) indicator also starts flashing on the display.

•Each time you press the button, the timer setting modes change as follows:

DAILY ON TIME REC

Canceled Clock ON TIME setting

(See page 9.)

2 Press CLOCK/TIMER again.

“ON TIME” appears for 2 seconds, then the unit enters on-time setting mode.

3 Set the on-time you want the unit to turn on.

1)Press 4 or ¢to set the hour, then press SET.

2)Press 4 or ¢to set the minute,

then press SET.

“OFF TIME” appears for 2 seconds, then the unit enters off-time setting mode.

4 Set the off-time you want the unit to turn off (on standby).

1)Press 4 or ¢to set the hour, then press SET.

2)Press 4 or ¢to set the minute, then press SET.

The unit enters source selecting mode.

5 Press 4or ¢to select the source to play, then press SET.

•Each time you press 4 or ¢, the source changes as follows:

TUNER FM TUNER AM

AUX TAPE – CD – –

TUNER FM: tunes into a specified preset FM station.

=go to step 6.

TUNER AM: tunes into a specified preset AM station.

=go to step 6.

– CD – –: plays a disc from a specified track of a specified disc. =go to step 6.

TAPE: plays a tape in deck A or B. = go to step 7.

AUX: plays an external source. = go to step 7.

– 20 –