JVC MX-J900 Speaker System User Manual and Installation Guide

Page 4

Introduction

We would like to thank you for purchasing one of our JVC products. Before operating this unit, read this manual carefully and thoroughly to obtain the best possible performance from your unit, and retain this manual for future reference.

About This Manual

This manual is organized as follows:

The manual mainly explains operations using the buttons and controls on the unit. You can also use the buttons on the remote control if they have the same or similar names (or marks) as those on the unit.

If operation using the remote control is different from that using the unit, it is then explained.

Basic and common information that is the same for many functions is grouped in one place, and is not repeated in each procedure. For instance, we do not repeat the information about turning on/off the unit, setting the volume, changing the sound effects, and others, which are explained in the section “Common Operations” on pages 9 to 11.

The following marks are used in this manual:

Gives you warnings and cautions to prevent damage or risk of fire/electric shock.

Also gives you information which is not good for obtaining the best possible performance from the unit.

Gives you information and hints you had better know.

Precautions

Installation

Install in a place which is level, dry and neither too hot nor too cold — between 5˚C (41˚F) and 35˚C (95˚F).

Install the unit in a location with adequate ventilation to prevent internal heat built-up in the unit.

Leave sufficient distance between the unit and the TV.

Keep the speakers away from the TV to avoid interference with TV.

DO NOT install the unit in a location near heat sources, or in a place subject to direct sunlight, excessive dust or vibration.

Power sources

When unplugging from the wall outlet, always pull the plug, not the AC power cord.

DO NOT handle the AC power cord with wet hands.

Moisture condensation

Moisture may condense on the lens inside the unit in the following cases:

After starting heating in the room

In a damp room

If the unit is brought directly from a cold to a warm place Should this occur, the unit may malfunction. In this case, leave the unit turned on for a few hours until the moisture evaporates, unplug the AC power cord, and then plug it in again.

Others

Should any metallic object or liquid fall into the unit, unplug the unit and consult your dealer before operating any further.

If you are not going to operate the unit for an extended period of time, unplug the AC power cord from the wall outlet.

DO NOT disassemble the unit since there are no user serviceable parts inside.

If anything goes wrong, unplug the AC power cord and consult your dealer.

– 1 –

Image 4
Contents Instructions For U.S.A Instructions for safe use Introduction PrecautionsAbout This Manual Contents Front Panel Location of the Buttons and ControlsFront Panel Powered Rolling Panel Display WindowRemote Control Remote ControlUnpacking Connecting Antennas Putting the Batteries into the Remote ControlGetting Started FM antennaConnecting Speakers AM antennaTo connect an outdoor AM antenna For better reception of both FM and AMConnecting Other Equipment Turning On or Off the Power Setting the ClockCommon Operations Selecting the SourcesAdjusting the Volume To turn down the volume level temporarilyReinforcing the Bass Sound Selecting the Sound ModesCreating Your Own Sound Mode Manual Mode To use your own sound modeSurround modes SEA Sound Effect Amplifier modesTuning in a Station Presetting StationsTuning in a Preset Station Listening to FM and AM BroadcastsPlaying Back CDs Loading CDsPlaying Back the Entire Discs Continuous Play Basic CD OperationsProgram other tracks you want Program PlayPress CD £·8 To check the program contents Playing at Random Random PlayRepeating Tracks or CDs Repeat Play Prohibiting Disc Ejection Tray LockPlaying Back a Tape Playing Back TapesLocating the Beginning of a Song Music Scan Recording To record on both sides Reverse ModeRecording a Tape on Deck B CD Direct Recording Dubbing TapesButtons CD1 to CD3 to select the disc, then Press DubbingAuto Edit Recording On the unit only Load CDsPress Edit Press SETUsing the Timers Using Daily TimerUsing Recording Timer When selecting CDWhen selecting Tuner FM or Tuner AM Press 4or ¢to set the volume levelUsing Sleep Timer Timer PriorityMaintenance TroubleshootingTo clean the disc Handling discsSpecifications HOW to Locate Your JVC Service Center Limited Warranty AUDIO-1 0100MWMMDWJEM