NordicTrack NTL1295.2 manual Assembly

ASSEMBLY

Assembly requires two persons. Set the treadmill in a cleared area and remove all packing materials. Do not dispose of the packing materials until assembly is completed.

Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This is a normal condition and does not affect treadmill performance. If there is lubricant on top of the walking belt, simply wipe off the lubricant with a soft cloth and a mild, non-abrasive cleaner.

Assembly requires the included allen wrench and your own phillips screwdriver and

wire cutters . For help identifying the assembly hardware, see the hardware drawings below.

Star Washer (67)–12	3/4” Tek Screw (44)–4	1” Tek Screw (82)–2
		Short Console
		Bolt (112)–2
Extension Screw	3/4” Screw (7)–2	Handrail Bolt (66)–4
(87)–4
Console Bolt (72)–2		Pulse Bar Bolt (127)–4

1.Open parts bag A. With the help of a second person, carefully raise the Uprights (85) and the Frame (55) to the position shown.

While the other person holds the Frame (55) and the Uprights (85), insert the Base Extension (90) into the two brackets on the lower end of the Uprights. Make sure that the Base Extension is turned so the Base Pads (81) are beneath it. Note: It may be helpful to tip the Uprights forward as you insert the Base Extension.

1	85
	55
	Brackets
81	85
	90
	81

6