NordicTrack NTL12905.0 manual Wire

7. Remove the Shock Pin (108) from the lower end of the	7
Shock (114).		55
Plug in the power cord as described on page 10, and		114
turn on the power as described on page 12. Next, press
the Incline increase and decrease buttons until the ball
on the bracket is aligned with end of the Shock (114).	85
Then, press the end of the Shock onto the ball. Note: It	108
may be necessary to press the end of the Shock onto the
	Bracket
ball while the Frame (55) is moving.
See drawing 7a. Insert the end of the Shock Pin (108)	7a
into two of the small holes in the end of the Shock (114).
Then, rotate the Shock Pin until it clips onto the Shock.
Press the Incline decrease button until the treadmill is at	108	114
the lowest incline level. Unplug the power cord. With the
help of a second person, lower the Frame (55) to the floor.
	Bracket

8.Make sure that all parts are properly tightened before you use the treadmill. Keep the included allen wrench in a secure place; the allen wrench is used to adjust the walking belt (see page 30). To protect the floor or carpet from damage, place a mat under the treadmill.

If you purchase the optional chest pulse sensor (see page 26), follow the steps below to install the re- ceiver included with the chest pulse sensor.

1.Make sure that the power cord is unplugged. Remove the indicated Screw (99) and the Access Door (95) from the left side of the Console Back (98).

2.Connect the wire on the receiver (A) to the indicated wire extending from the Console Back (98). Hold the re- ceiver so the small cylinder is oriented as shown and is facing the Console Back. Attach the receiver to the plastic posts on the Access Door (95) with the two in- cluded small screws.

3.Make sure that no wires are pinched. Reattach the Access Door (95) with the Screw (99). Discard the other wires included with the receiver.

98	Wire
	Small
	Screws
95
	A
	Small
99	Cylinder

9