JVC CA-UXV100, SP-UXV100, UX-V100 manual Care and Maintenance

Page 24

Care and Maintenance

Handle your CDs carefully, and they will last a long time.

Compact Discs

• Only CDs bearing this mark can be used with this System. However, continued use of irregular shape CDs (heart-shape, octagonal, etc.) can damage the System.

If there are fingerprints, etc. on the lens, gently wipe clean with a cotton swab.

Remove the CD from its case by holding it at

the edges while pressing the case’s center hole lightly.

• Do not touch the shiny surface of the CD, or bend the CD.

Put the CD back in its case after use to prevent

warping.

Be careful not to scratch the surface of the CD when placing it back in the case.

Avoid exposure to direct sunlight, temperature extremes, and moisture.

• A dirty CD may not play correctly. If a CD does become dirty, wipe it with a soft cloth in a straight line from center to edge.

CAUTION: Do not use any solvent (for example, conventional record cleaner, spray thinner, benzine, etc.) to clean a CD.

General Notes

In general, you will have the best performance by keeping your CDs and the mechanism clean.

Store CDs in their cases, and keep them in cabinets or on shelves.

Keep the system’s CD cover closed when not in use.

Cleaning the Lens

If the lens in the CD pickup is dirty, sound degradation may take place.

Open the CD cover and clean the lens as shown.

Use a blower (available from a camera store) to blow dust off the lens.

Blower

Lens

20

Moisture Condensation

Moisture may condense on the lens inside the System in the following cases:

• After turning on heating in the room

In a damp room

If the System is brought directly from a cold to

a warm place

Should this occur, the System may malfunction. In this case, leave the System turned on for a few hours until the moisture evaporates, unplug the AC power cord, and then plug it in again.

Cassette Tapes

If the tape is loose, it may get stretched, cut, or caught in the cassette. Take up the slack by

inserting a pencil in one of the reels and rotating.

Do not touch the tape surface.

Do not store the tape:

- In dusty places

- In direct sunlight or heat - In moist areas

-On a TV or speaker

-Near a magnet

Cassette Deck

If the heads, capstans, or pinch-rollers of the Cassette Deck become dirty, the following may occur:

-Loss of sound quality

-Discontinuous sound

-Fading

-Incomplete erasure

-Difficulty in recording

Clean the heads, capstans, and pinch-rollers using a cotton swab moistened with alcohol.

Capstans

Pinch-rollers

Erase head

Record/play head

If the heads become magnetized, the Unit will produce noise or lose high frequency notes.

To demagnetize the heads, turn off the Unit, and use a head demagnetizer (available at electronics and record shops).

EN10-22.UX-V100[B]f

20

12/12/00, 12:34 PM

Image 24
Contents Micro Component System UX-V100- Consists of CA-UXV100 and SP-UXV100If in Doubt Consult a Competent Electrician Reproduction of LabelsClassification LABEL, Placed on Rear Enclosure Class 1 Laser ProductUX-V100 Above ALL Table of Contents Accessories How to Put Batteries in the Remote ControlUsing the Remote Control Getting StartedConnecting the FM Antenna Connecting the AM MW/LW AntennaUsing the supplied Wire Antenna Using the coaxial type connector not suppliedConnecting the Speakers Connecting External EquipmentLine in AUX Connecting the AC Power Cord On the Unit On the Remote ControlTurning the Power On and Off Adjusting the VolumeCommon Operations Turning the System onAdjusting the bass level Adjusting the treble levelReinforcing the Bass Sound AHB PRO Controlling the Tone Bass/ TrebleUsing the Tuner Tuning In a StationPresetting Stations Presetting stations manuallyChanging the FM Reception Mode Presetting stations automaticallyTo restore the stereo effect, press the FM Mode button on Press the SET button within 5 secondsUsing the CD Player Inserting a CDUnloading a CD Quickest way to start a CD is with the one touch operationBasics of Using the CD Player Normal Play Programing the Playing Order of the TracksPress the Random button on the Remote Control Press the Repeat button on the Remote ControlPlaying at Random Repeating TracksUsing the Cassette Deck Listening to a Tape Reverse ModeStandard Play One touch playUsing the Cassette Deck Recording Standard RecordingThings to know before you start recording Check the recording direction for the tapeCD Direct Recording One track recordingPress the CD #/8 button twice To stop at any time during the recording process, pressUsing External Equipment AUX AHB PRO Volume +Listening to External Equipment To exit from AUX mode, select another sourceUsing the Timers Setting the Daily TimerSetting the Clock Setting the Recording Timer Setting the Sleep Timer Insert a blank or erasable tape into the Cassette DeckCare and Maintenance Troubleshooting SymptomPossible Cause ActionSpecifications 1200MWMMDWJEM