NordicTrack NTL2295.0 user manual Troubleshooting, Problem The power turns off during use, Top

Page 30

TROUBLESHOOTING

Most treadmill problems can be solved by following the steps below. Find the symptom that applies, and follow the steps listed. If further assistance is needed, see the front cover of this manual.

PROBLEM: The power does not turn on

SOLUTION: a. Make sure that the power cord is plugged into a surge suppressor, and that the surge suppressor is plugged into a properly grounded outlet (see page 11). Use only a single-outlet surge suppres- sor that meets all of the specifications described on page 11. Important: The treadmill is not com- patible with GFCI-equipped outlets.

b. After the power cord has been plugged in, make sure that the key is fully inserted into the console.

c. Check the reset/off circuit breaker located on the treadmill frame near the power cord. If the switch pro- trudes as shown, the circuit breaker has tripped. To reset the circuit breaker, wait for five minutes and then press the switch to the reset position.

c

Tripped

Reset

PROBLEM: The power turns off during use

SOLUTION: a. Check the reset/off circuit breaker (see the drawing above). If the circuit breaker has tripped, wait for five minutes and then press the switch to the reset position.

b. Make sure that the power cord is plugged in. If the power cord is plugged in, unplug it, wait for five minutes, and then plug it back in.

c. Remove the key from the console. Reinsert the key fully into the console.

d. If the treadmill still will not run, see the front cover of this manual.

PROBLEM: The displays of the console do not function properly

SOLUTION: a. Remove the key from the console and unplug the power cord. Carefully tip the treadmill down as shown in drawing a. Remove the Screws (87) from the Motor Hood (33). Raise the Upright (20) and care- fully remove the Motor Hood.

Locate the Reed Switch (22) and the Magnet (18) on the left side of the Pulley (17). Turn the Pulley until the Magnet is aligned with the Reed Switch. Make sure that the gap between the Magnet and the Reed Switch is about 1/8”. If necessary, loosen the Screw (23), move the Reed Switch slightly, and then retighten the Screw. Reattach the Hood (33) with the Screws (87). Run the treadmill for a few minutes to check for a correct speed reading.

a

 

 

20

87

87

 

33

1/8”

17

23

 

22

18

Top

 

View

 

30

Image 30
Contents QUESTIONS? Model No. NTL2295.0 Serial NoCall TOLL-FREE Table of Contents Important Precautions Page Before YOU Begin Assembly Page Upright, and firmly tighten the four Handrail Bolts NotCut Page Chest Pulse Sensor Care and Maintenance HOW to USE the Chest Pulse SensorHOW to PUT on the Chest Pulse Sensor Chest Pulse Sensor TroubleshootingOperation and Adjustment HOW to Plug in the Power CordPRE-LUBRICATED Walking Belt Features of the Console HOW to Turn on the Power HOW to USE the Manual ModeFollow your progress with the display Measure your heart rate if desired Turn on the fans if desiredWhenkey. you are finished exercising, remove HOW to USE a Preset Program Select one of the preset programsAdjust the intensity level of the program if Desired See on HOW to Create a Custom Program Select one of the custom programsHOW to USE a Custom Program HOW to USE a Heart Rate Program Enter a maximum target heart rate settingSelect a heart rate program Follow your progress with the displays HOW to Connect Your MP3 Player or CD Player HOW to Connect Your Portable StereoAudio Cable HOW to Connect Your Home Stereo HOW to Connect Your ComputerMeasure your heart rate if desired HOW to Connect Your VCR Press the Play button on your MP3 player, CD Player, or VCRDirectly from OUR WEB Site Follow the on-line instructions to start ProgramReturn to the treadmill and stand on the foot Information MODE/DEMO Mode HOW to Fold and Move the Treadmill HOW to Fold the Treadmill for StorageHOW to Move the Treadmill HOW to Lower the Treadmill for USE Troubleshooting Problem The power turns off during useTop Problem The walking belt slows when walked on Problem The treadmill rocks during useProblem The chest pulse sensor does not function properly Workout Guidelines Conditioning GuidelinesExercise Intensity Exercise FrequencyR0506A Qty DescriptionOrdering Replacement Parts Exploded DRAWING-Model No. NTL2295.0 112 113 106 105 107 Limited Warranty