NordicTrack NTL2295.0 user manual Assembly

ASSEMBLY

Assembly requires two persons. Set the treadmill in a cleared area and remove all packing materials. Do not dispose of the packing materials until assembly is completed.

Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This is a normal condition and does not affect treadmill performance. If there is lubricant on top of the walking belt, simply wipe off the lubricant with a soft cloth and a mild, non-abrasive cleaner.

Assembly requires the included allen wrench and your own phillips screwdriver ,

standard screwdriver and wire cutters . For help identifying the assembly hard- ware, see the hardware drawings below. To avoid damaging plastic parts, do not use power tools for as- sembly.

Cover Screw (90)–2	1” Tek Screw (82)
Star Washer (67)–12
Base Plate Bolt (125)–3	Handrail Bolt (66)–4
Short Console
Bolt (112)–2
Console Bolt (72)–2	Pulse Bar Bolt (13)–4

1.With the help of a second person, tip the Upright (20) down as shown. Next, slide the treadmill out of the box.

Attach the four Base Pads (81) and two Pad Spacers (A) to the bottom of the Upright (20) with the four 1” Tek Screws (82) in the locations shown.

Thread the two Leveling Feet (130) into the bottom of the Upright (20).

Insert the three Cage Nuts (128) into the three indicated holes in the treadmill. To insert each Cage Nut, first hook one side of the Cage Nut into a hole. Then use a stan- dard screwdriver to press the other side of the Cage Nut into the hole, as shown

1	82
37
82		81
	81
130		82
		37
	128	20
		130
		128

6