HOW to Turn on the Power

1 Plug in the power cord (see page 11).

2	Locate the reset/off
2	circuit breaker near
	the power cord. Make	On
		On
		Position
	sure that the circuit	Position
	sure that the circuit
	breaker is in the reset
	position.
	position.

Stand on the foot rails of the treadmill. Find the clip

3 attached to the key (see the drawing on page 12) and attach the clip securely to the waistband of your clothes. Next, insert the key into the console. After a moment, the display will light. Note: When the power is turned on, the program that was se- lected the last time the Save button was pressed will automatically be reselected. If the Save button has not yet been pressed, the manual mode will be selected.

Test the clip by carefully taking a few steps backward until the key is pulled from the con- sole. If the key is not pulled from the console, adjust the position of the clip as needed.

HOW TO USE THE MANUAL MODE

1 Insert the key into the console.

See HOW TO TURN ON THE POWER above.

2 Designate yourself as user A, B, C, or D.

The console can save program settings for up to four different users. To designate yourself as user A, B, C, or D, press one of the Personal Setting buttons labeled A, B, C, and D.

3 Select the manual mode.

To select
the manual
mode, press
the
Programs	Track
button re-

peatedly

until a track appears in the center of the display. Make sure that the word “Programs” does not ap- pear below the track.

4 Start the walking belt.

To start the walking belt, press the Start button, the Speed increase button, or one of the twelve 1-Step Speed buttons.

If the Start button or the

Speed increase button is pressed, the walking belt will begin to move at

1 mph. As you exercise, change the speed of the

walking belt as desired by pressing the Speed in- crease and decrease buttons. Each time a button is pressed, the speed setting will change in incre- ments of 0.1 mph; if a button is held down, the speed setting will change in increments of 0.5 mph. Note: After the buttons are pressed, it may take a moment for the walking belt to reach the se- lected speed setting.

If one of the 1-Step Speed buttons is pressed, the walking belt will gradually increase in speed until it reaches the selected speed setting.

To stop the walking belt, press the Stop button. The time will begin to flash in the display. To restart the walking belt, press the Start button, the Speed increase button, or one of the 1-Step Speed buttons.

5 Change the incline of the treadmill as desired.

To change the incline of the treadmill, press the Incline increase and decrease buttons or one of the twelve 1-Step Incline buttons.

Each time the Incline in-

crease or decrease but- ton is pressed, the incline will change by 0.5%.

Note: After the buttons are pressed, it may take a

moment for the treadmill to reach the selected in- cline setting.

If one of the 1-Step Incline buttons is pressed, the incline will gradually increase until it reaches the selected incline setting.