ASSEMBLY
Assembly requires two people. Set the treadmill in a cleared area and remove all packing materials. Do not dispose of the packing materials until assembly is completed. Assembly requires the included allen wrench
and your own 
, wire cutters 
and adjustable
wrench 
.
Note: The underside of the treadmill walking belt is coated with
1.Slide the treadmill out of the box. Insert the three Cage Nuts (96) into the three indicated holes in the treadmill.
To insert each Cage Nut (96), first hook one side of the Cage Nut into the hole and then use a
2.With the help of a second person, carefully raise both Uprights (99) to a vertical position. Press the Lock Knob Sleeve (111) and the Lock Knob Spacer (112) into the left Upright.
Remove the Lock Knob (113) from the Lock Pin (107). Make sure that the Lock Pin Collar (109) and the Spring
(110)are on the Lock Pin. (Note: If there are two Lock Pin Collars, place one on each side of the Spring.) Insert the Lock Pin into the Lock Knob Sleeve (111) and the Left Upright (99).
Tighten the Lock Knob (113) onto the Lock Pin (107).
3.With the help of a second person, carefully raise the Walking Platform (24) to the storage position and make sure that the lock pin is properly engaged as described on page 25.
Position the Base Plate (91) on the treadmill as shown. Attach the Base Plate with the three Base Plate Screws (92). Note: It may be helpful if a second person tips the treadmill slightly as you tighten the Screws.
Carefully lower the Walking Platform (24) to the floor as described on page 25.
1 |
|
96 |
|
| 96 |
2 |
|
| 99 |
113 | 112 |
| 110 |
| 107 |
| 111 |
| 109 |
3 | 24 |
| |
| 92 |
91 |
|
6