INTRODUCTION |
|
|
IMPORTANT |
PRECAUTIONS |
P R E-ASS E M B LY
DO NOT ATTEMPT TO LIFT THE TREADMILL!* Do not move or lift
WARNING treadmill from packaging until specified to do so in the assembly instructions. Failure to do so may result in injury! Remove plastic wrap from console masts.
Note: During each assembly step, ensure that ALL nuts and bolts are in place and partially threaded in
before completely tightening any ONE bolt. NOTE: A light application of grease may aid in the installation of hardware. Any grease, such as lithium bike grease is recommended.
A S S E M B LY STEP 1
HARDWARE BAG 1 CONTENTS :
BOLT (A) | FLAT WASHER (B) | TEFLON WASHER (C) |
15 mm | 20 mm | 18 mm |
Qty: 1 | Qty: 1 | Qty: 1 |
BOLT (D) | FLAT WASHER (E) | WAVY WASHER (F) |
Qty: 1 | 27 mm | 29 mm |
| Qty: 1 | Qty: 1 |
IMPORTANT PRECAUTIONS INTRODUCTION
ASSEMBLY |
|
YOU |
BEFORE |
BEGIN |
|
|
TREADMILL OPERATION |
|
DO NOT |
EXCEED |
45 DEGREES! |
ACut the yellow banding straps.
BRaise the deck slightly
– no more than 45 degrees – to remove all contents from underneath the deck.
| MAIN FRAME |
LEFT CONSOLE MAST |
|
WAVY WASHER (F) |
|
FLAT WASHER (E) |
|
BOLT (D) |
|
LEFT LINKAGE ARM |
|
BOLT (A) | ELEVATION FRAME |
FLAT WASHER (B) |
|
TEFLON WASHER (C) |
|
A | Open HARDWARE BAG 1. |
B | Move left linkage arm into position. Insert 1 bolt (A) and 1 FLAT WASHER (B) into left linkage |
| arm followed by 1 teflon washer (C) and attach to elevation frame. |
ASSEMBLY
BEFORE YOU BEGIN
TREADMILL OPERATION
GUIDELINES |
| |
CONDITIONING |
| |
&MAINTENANCE |
|
|
TROUBLESHOOTING |
|
|
|
| |
LIMITED |
|
|
WARRANTY |
| |
|
| |
|
|
|
*Note: If you have lifted the treadmill deck too far or attempted to move the machine and it has sprung open and cannot be assembled, refer to the troubleshooting section in order to restore the treadmill to its proper position.
C Lift left console mast into upright position. Be sure to hold the |
console mast firmly, as it will not stay in the upright position on its own. |
D Insert 1 bolt (D) and 1 FLAT washer (E) through left console |
mast followed by 1 WAVY washer (F) and attach to MAIN FRAME. |
Note: Do not completely tighten any screws or bolts until step 6 is complete!
LIMITED TROUBLESHOOTING CONDITIONING WARRANTY & MAINTENANCE GUIDELINES
T901_Rev.2.0.indd | 9/10/08 11:15:21 AM |