Reebok Fitness RBTL12920 manual Uprights 65 as shown, with the Bumpers 98 under

3. (Note: The parts shown in this step may be preassembled	3
but may need to be adjusted.) With the help of a second per-
son, raise the Frame (55) and hold it. Insert the Left Frame
Guide (68) into the left side of the Frame. Remove the Lock		Hole	55
Knob (67) from the Lock Pin (72). Be sure the Lock Pin				10
Collar (70) and the Spring (69) are on the Lock Pin. Insert			70	5
the Lock Pin into the Frame and the Left Frame Guide.			72
Press the Latch Insert (5) onto the Frame, with the Lock Pin
in the center hole. Tighten the Lock Knob onto the Lock Pin.				69	67
	68
		62
Align the Lock Pin (72) with the hole in the Left Foam Grip
(62) by sliding the Left Frame Guide (68) up or down.
Make sure that the Lock Pin can be inserted fully into the
hole. Hold the Left Frame Guide in place and tighten two
1/2” Screws (10) into the Latch Insert and the Left Frame
Guide. Note: It may be necessary to pull the Lock Knob
(67) to access and tighten the Screws.
4. Raise the treadmill to the storage position (see HOW TO	4
FOLD THE TREADMILL FOR STORAGE on page 21).
	26
		51
	129
Have a second person hold the treadmill in the upright posi-
tion. Position the U-base (20) against the base of the
Uprights (65) as shown, with the Bumpers (98) under the
U-base.Finger tighten two 2” Bolts (26) with Base
Washers (129) into the base of the Uprights and the U-
base. Then, attach the U-base with two 3” Bolts (23), two		23	26		51
Base Washers (129), and two U-base Nuts (51). Tip the
treadmill forward if necessary. Tighten the two 2” Bolts.		65
5. Make sure that all parts are properly tightened before			129
	98
you use the treadmill. Place a mat beneath the tread-		20
mill to protect the floor. For your benefit, familiarize your-		98		23
self with the information on pages 23 and 24.
If you purchase the optional chest pulse sensor (see page	1
20), follow the steps below to install the receiver and the
short jumper wire included with the chest pulse sensor.
1. Make sure that the power cord is unplugged. Remove the
indicated Screws (40) from the Console Back (117). Remove
the Console Back.
			117
2. Connect the Short Jumper Wire (A) to the wire on the		40	40
	2
Receiver (B). Connect the other end of the Short Jumper
Wire to the PULSE jack on the back of the Console (80).
Turn the Receiver (B) so the cylinder is on the side		80
shown, and hold the Receiver against the back of the
		A		Cylinder
Console (80). Attach the Receiver with the two Small
Screws (C) included with the receiver.				B
		C

Make sure that no wires are pinched. See step 1.

Reattach the Console Back (117) with the 3/4” Screws (40).

You may discard the other wires included with the receiver.

7