2.Insert an Extension Leg (97) into the Base (85) as shown. If necessary, use a rubber mallet to fully insert the Extension Leg. Next, hold two Extension Leg Nuts (10) in the bottom of the Extension Leg, and tighten two 5/16" x 2" Bolts (2) with two 5/16" Star Washers (9) into into the top of the Extension Leg.
3.Hold the Right Upright (113) near the Base (85). Insert the Upright Wire Harness (73) into the bot- tom of the Right Upright and out the top.
Attach the Right Upright (113) to the Base (85) with a 3/8" x 1" Bolt (4), a 3/8" x 2 3/4" Bolt (5), and two 3/8" Star Washers (8). Make sure that the Upright Wire Harness (73) is not pinched. Start both Bolts before tightening them.
4.Slide the Right Base Leg Cover (83) over the end of the Right Upright (113). Attach the Right Base Leg Cover with two #8 x 2 1/4" Screws (7) and three #8 x 3/4" Screws (6). Be careful not to overtighten the Screws.
2 |
|
| 85 |
| 9 |
| 2 |
| 10 |
| 97 |
3 |
|
73 | 113 |
| |
| 85 |
| 73 |
| 8 |
| 5 |
| 4 |
| 8 |
4 |
|
| 113 |
| 83 |
| 6 |
| 7 |
7