Reebok Fitness R T 6.0 manual Troubleshooting, Symptom The power turns off during use

Page 23

TROUBLESHOOTING

Most treadmill problems can be solved by follow- ing the simple steps below. Find the symptom that applies, and follow the steps listed. If further assis- tance is needed, see the front cover of this manual.

SYMPTOM: The power does not turn on

a.Make sure that the power cord is plugged into a surge suppressor and that the surge suppressor is plugged into a properly grounded outlet (see page 14). Use only a surge suppressor that meets all of the specifications described on page 14.

IMPORTANT: The treadmill is not compatible with GFCI-equipped outlets and may not be compatible with AFCI-equipped outlets.

b.After the power cord has been plugged in, make sure that the key is inserted into the console.

c.Check the power switch located on the treadmill frame near the power cord. If the switch protrudes as shown, the switch has tripped. To reset the power switch, wait for five minutes and then press the switch back in.

c

Tripped

Reset

SYMPTOM: The power turns off during use

a.Check the power switch (see the drawing above). If the switch has tripped, wait for five minutes and then press the switch back in.

b.Make sure that the power cord is plugged in. If the power cord is plugged in, unplug it, wait for five minutes, and then plug it back in.

c.Remove the key from the console, and then reinsert it.

d.If the treadmill still will not run, please see the front cover of this manual.

SYMPTOM: The console displays remain lit when you remove the key from the console

a.The console features a display demo mode, designed to be used if the treadmill is displayed in a store. If the displays remain lit when you remove the key, the demo mode is turned on. To turn off the demo mode, hold down the Stop button for a few seconds. If the displays are still lit, see THE INFORMATION MODE on page 21 to turn off the demo mode.

SYMPTOM: The displays of the console do not function properly

a.Remove the key from the console and UNPLUG THE POWER CORD. Next, place the treadmill in the storage position (see HOW TO FOLD THE TREADMILL on page 22). Then, remove the two indicated #8 x 3/4" Screws (6).

a

 

6

6

 

23

Page 22 Page 24
Image 23
Page 22 Page 24
Contents Mon.-Fri a.m.-6 p.m. MT Sat a.m.-4 p.m. MT QUESTIONS?Model No. RBTL69211.0 Serial No Call TOLL-FREETable of Contents Important Precautions Page Before YOU Begin Part Identification Chart Age the Upright Wire AssemblyMake sure that the power cord is unplugged Wire To pinch the Upright Wire 70. Do not tighten Screws yet Page Nectors PROPERLY, the Console MAY Become Damaged When YOU Turn onSix Screws, and then tighten them Make sure that no wires are pinched. InsertTighten the Screws yet Attach the other Wheel 81 in the same way Use a Surge Suppressor Operation and AdjustmentHOW to Connect the Power Cord Console Diagram Features of the Console HOW to USE the Manual Mode HOW to Turn on the PowerYour hands Left display-The left display will showRate, stand on Foot rails Avoid movingStart the workout HOW to USE AN Onboard WorkoutSelect an onboard workout Select a weight loss workout HOW to USE the Weight Loss CenterInsert an iFit card and select a workout HOW to USE AN Ifit WorkoutHOW to USE the Stereo Sound System Information ModeHOW to Lower the Treadmill for USE HOW to Fold and Move the TreadmillHOW to Fold the Treadmill HOW to Move the TreadmillSymptom The power turns off during use TroubleshootingSymptom The walking belt slows when walked on Page Exercise Frequency Exercise GuidelinesExercise Intensity Workout GuidelinesKey No. Qty Description Part ListExploded Drawing a Exploded Drawing B Exploded Drawing C Exploded Drawing D Icon Health & Fitness, Inc., 1500 S W., Logan, UT Ordering Replacement PartsLimited Warranty
Top Page Image Contents